Videos
for UTV Windshields
Help Articles
for UTV Windshields
Expert Answers
for UTV Windshields
I attached install instructions for the Classic Accessories part #CA78637 which is a back window for your Yamaha Rhino. It's pretty easy. Basically you just attach the top straps first and then work your way down making sure it's…
view full answer...I have attached an image of the dimensional drawing for the Gen-Y Hitch Shock Absorbing 5th Wheel Pin Box #GY68GR.
view full answer...The Electric Jack w/ Footplate is offered both with the plug part #EJ-3527-BBX and without the plug part #EJ-3520-BBX. Therefore, if you wanted to go with the model that has the plug and just cut that off you would indeed just run the wire to the…
view full answer...Gen-Y's calculation for pin weight is a safe guess, but isn't the most accurate so the only way you'll get the correct capacity Gen-Y 5th Wheel Pin Box is to fully load the trailer and go to a commercial scale to measure the…
view full answer...I spoke with my rep at Dexter axle and was informed your axle has a 3,500 lbs weight capacity, with a 58" spring center, and a 72" hub face. A comparable replacement is the Dexter Trailer Idler Axle Beam with EZ-Lube Spindles -…
view full answer...According to the installation instructions from Dexter Axle the torque specs for the wet bolts on their Dexter E-Z Flex Suspension Kits, like part #K71-653-00, is 30 - 50 ft-lbs. I have attached a clip from their instructions for you to check out.
view full answer...I spoke with the manufacturer and they recommend using 160 ft-lb for the torque spec on a 3/4 inch U-bolt #11-70.
view full answer...On trailer brakes the small shoe points towards the front of the trailer, and the larger shoe points towards the rear. This allows the trailer brakes to apply correctly when the magnet for electric brakes is activated, or the wheel cylinder is…
view full answer...The slipper spring should sit on the hanger bolt somewhere in the center of the flat part so that it allows a bit of movement as the suspension articulates. The curved ends will generally going to keep the spring from moving too far if the…
view full answer...It's hard to see in your picture but is the hanger open on the one side which allows the spring to slide out to the side? It shouldn't be open like that. If you need a replacement hanger we have the #115706S for if you have a 1-3/4…
view full answer...While we do not have the ability to pull part numbers from OEM build sheets, from images online it appears similar to #PLR5115. The measurement on this option is 5-1/2" by 4-1/4" requires a cutout of approximately 4-5/8"…
view full answer...I took a look at the Bargman Door Latch 10-30-051 that you referenced and it is indeed oversized. The best option we have to replace this would be the Global Link RV Entry Door Locking Latch Kit part #295-000019 which can install in an opening up to…
view full answer...