Videos
for Tree Saver Straps
Help Articles
for Tree Saver Straps
Expert Answers
for Tree Saver Straps
The installation instructions for this product are recommended for individuals who have experience winding torsion springs. If you have not worked with a torsion spring system before, we recommend contacting a local garage door company to install…
view full answer...If your current springs have 5 leaves then going to a 7 leaf spring will increase the height of the trailer a little and make the trailer more susceptible to sway. Regarding capacity if you go with springs rated higher than what is required it will…
view full answer...Lippert does not recommend using ATF Type F Fluid as it is not compatible with Lippert hydraulic system #LC251910 seals because they will not work properly. The following automatic transmission fluid (ATF) recommendations for use in Lippert…
view full answer...I've checked with Lippert in the past and for their hydraulic leveling systems they recommend Dexron III or Mercon 5 automatic transmission fluid.
view full answer...Blue Ox has an easy system for determining the weight capacity of your spring bars, whereas other companies may use measurements or printed capacity to assist. With Blue Ox, there is a 5 dimple system: No dimples means it is rated for up to 350 lbs…
view full answer...To wire two 6-volt batteries in series to produce 12-volts, you would connect the load to the positive terminal of battery #1. Connect the negative terminal of battery #1 to the positive terminal of battery #2. Ground the negative terminal of battery…
view full answer...If you look at the backs of the brake assemblies there should be a hole where the magnet wires come out and a little opaque plastic strap. So if you are looking at the back of the assembly and those items are on the left then it is the left side…
view full answer...The H78-15ST tire size is the same as the 225/75-15 tire size like the part #TTWSF22515D that you referenced. I would recommend the radial version of this tire #TTWTRTM2257515D over the one you referenced as it is a bias ply. Radial tires run cooler…
view full answer...I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…
view full answer...First you would need an engine oil cooler kit. I recommend #D15502 because it comes with multiple thread types and has the proper O-ring size for a V-6 Toyota motor. The sandwich adapter included is thermostatic so a separate thermostat is not…
view full answer...Westin has a Grate Step Nerf Bar kit that fits your 2010 Dodge Ram 2500 Crew Cab with the part #27-74765-1905 which comes with all of the needed install hardware and is a confirmed fit for your truck. You wouldn't have to worry about this not…
view full answer...We have that size (see link), but none of the tires are radial. They are all bias ply as that is the common construction for the LT tires. The closest tire size that is radial would be the 235/80R16 like part #TTWTRTM2358016E. This size has a section…
view full answer...