Videos
for Padlocks
Help Articles
for Padlocks
Expert Answers
for Padlocks
We don't have an option that will allow for all of them to be keyed alike but I can get you down to one key for the hasp locks and another for the coupler lock. The Trimax Puck Locks for Trailer Door Hasps #TMX73FR comes with three…
view full answer...Thanks for reaching out, Mark! The Scissor Stabilizer Jacks w/ Handle - 18-3/4" Lift - 10,000 lbs #TJSCHD-24-4 are designed with 11 Gauge steel and install using 1/4" self-tapping screws like the Self-Tapping Screw #FA1131822. Then…
view full answer...Hey Gary, so the Yakima 54" Tracks for Roof Racks #Y26RR that you referenced are compatible with your setup as they provide the standard dimension roof tracks that your Sherpa Crows Nest was designed to fit. With that said the correct…
view full answer...Good news! I was able to get a exploded diagram as well as a set of instructions on how to replace the rod and gears #TJD-12000-RODNUT in the #12000 Series Ram Jacks made after 2012. I have attached them to this page for your convenience.…
view full answer...In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.
view full answer...I did some research and found that the 12194TC seal you said you have measures 1.250 inside diameter, and 1.979 outside diameter. The seal I recommend is part #34823. The dimensions listed for this seal are 1.249 inside diameter and 1.983 outside…
view full answer...If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…
view full answer...The Curt SecureLatch Lunette Ring with 8-Position Adjustable Channel #CU49FR does come with the hardware needed to attach the lunette ring to the channel. It is 3 bolts, 3 nuts and 6 washers. The picture below shows every piece you would receive. If…
view full answer...To replace your NOK AD2527E seal you can use #168233. It has an inner diameter of 1.688 inches and an outer diameter of 2.332 inches. Based on what I could find on the NOK AD2527E the inner diameter is the same and the outer diameter is 2.328 inches.…
view full answer...I really wish it did because we get these questions all the time. The B&W Patriot Slider item #BWRVK3270 won't work with the picture frame style adapters. It has to do with the spacing and also the height of the slider. The item #RP30156, and…
view full answer...The #99 trailer spindle is typically found on 9,000 lb and 10,000 lb axles. This is not a spindle that we carry at this time, but I did find some of the measurements. I have attached a diagram showing the dimensions of a #99 spindle for you to check…
view full answer...The working load limit for the E-Track system like the part #E19148 that you referenced is 2,000 lbs. There isn't a set method required for tightening a load to the E-Track. Basically you would want to use a properly rated strap for the weight of…
view full answer...