Filter Products
Filter by Table Type
$91.16 - $108.65
Videos
for Boat Tables
Help Articles
for Boat Tables
Expert Answers
for Boat Tables
I've gone ahead and pulled the Octogon Boat Table #315-DSI-KF from our inventory to measure for your specific question. There is a depth of 2-1/4 inches from the top of the cup holder to the very bottom. If you notice in the…
view full answer...For your 28' enclosed trailer I recommend the Furrion Chill HE RV Air Conditioner System - Single Zone - 15,000 Btu - Black #FR23PV. If the ceiling of the trailer isn't too high and you can reach the air distribution…
view full answer...I have attached a chart you can check out that describes the torque needed per wheel size, wheel stud size and material. For an 8-inch wheel with a 1/2-inch wheel stud the torque is 75 to 86 ft-lbs. For a 15 inch steel wheel with 1/2 inch wheel…
view full answer...The Table Leg #315-DTX that comes with the Rectangular Boat Table #315-DSH-KF is 2" OD. The ends of the tube are tapered down to 1-7/8" OD for the Mounting Brackets #315-DTY and #JIF54FR.
view full answer...The #CE27648 Guide Ons you'd looked at are designed for I-beam trailer frame members, from the photo you provided, it looks like your frame members are a simple boxed in rectangular tube. If that's the case, and the…
view full answer...The difference between a load range E and load range F tire of the same size, 235/85-16, is the weight capacity and pressure. The Karrier Radial Tire, Load Range E, #AM10295, has a capacity of 3,640 pounds at 95 psi. The Load Range F Tire,…
view full answer...The outside diameter of the Table Leg #315-DTX for the Octagonal Boat Table #315-DSI-KS is 2" in diameter. The end of the leg does taper down to 1-7/8".
view full answer...There are a few things that you will need to know in order to choose the right disc brake kit for your 2003 DHM boat trailer. I assume you have idler hubs and are replacing your brakes so you already have a 4-bolt brake mounting flange #4-35 as…
view full answer...For your Lippert Components Power Stabilizer Trailer Jack #LC298707 the wiring is pretty simple. There are two wires that come out of the motor and they are both used as power or ground depending on the direction you want to turn the motor. To…
view full answer...For your Fulton F2 Swing-Up Trailer Jack, Dual 7" Wheels, Sidewind, Bolt-On - 1,600 lbs #F1413020134 part number 9 you referenced is not a replacement option. The outer tube components are not replaceable according to my contact at…
view full answer...I spoke with Lippert about the Lippert Components Kwikee Step Frame 28 Series Step part #LC3747457 and unfortunately, they do not provide any mounting information as this is done through the trailer manufacturer. They did however state that you…
view full answer...I cannot say for sure how you can tell whether or not you have the converter on your Highlander but I can help you out with the trailer harness installation. The only sure way to tell which harness you need is to check out what wiring you have in…
view full answer...