Filter by Type of Accessory
$12.81 - $12.81
Videos
for Boat Motor Accessories
Help Articles
for Boat Motor Accessories
Expert Answers
for Boat Motor Accessories
We do not have any hub caps that fit trailer wheels. If you were wanting to go with something nicer looking you'd need to replace the wheel with something like the Westlake ST205/75-14 part #WST57FR or any of the other aluminum…
view full answer...The issue you most likely ran into is that winches draw way more amperage than what the 12 volt accessory wire of your 7-way can provide. You would have needed something like the part #BDW20207 to power your winch. Your going to have to start…
view full answer...The difference between a load range E and load range F tire of the same size, 235/85-16, is the weight capacity and pressure. The Karrier Radial Tire, Load Range E, #AM10295, has a capacity of 3,640 pounds at 95 psi. The Load Range F Tire,…
view full answer...Hey Rob; thanks for the photos and it was actually the one with the hub number that did it. That's a BD 545 which is an AxleTek 3,500 lb hub and drum like the Trailer Hub and Drum Assembly #AKHD-545-35-K. The 35 on the axle…
view full answer...I recommend the Tourney Pro Transom Saver #315-FXJ for your 5'x8' plastic boat. The transom saver is definitely recommended with the lightweight plastic boat you have. With this transom saver you can mount it to the…
view full answer...Yes, the Timbken bearings part #TMK73VR and #TMK23VR are made in the USA.
view full answer...The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13…
view full answer...A BT8 spindle would have a diameter of .99 of an inch where the bearings would both install and would have a diameter of 1.24 where the great seal would ride. That would require a hub part #AKIHUB-440-2-1K for an idler hub. A BTR spindle would have…
view full answer...We do have a potential solution for you, but the Replacement Inner Member #DX99FR is not a suitable replacement for the TDE 8000LP. The #DX99FR is made only for Dexter DX7.5L and Legacy UFP actuators. The pins will not line up with a TDE I am sorry…
view full answer...Since both a ST145/R12 size tire, like the Kenda Karrier S-Trail #AM10130, and a 5.30-12 size tire, like the Kenda K353 #AM10068, fit a 12 inch wheel, a ST145/R12 size tire can replace a 5.30-12 size tire. Keep in mind that these tires do have…
view full answer...For the Lippert Components Standard 5th-Wheel Landing Gear Motor w/ IP Rated Switch and Harness #LC217884, which is for LCI Power Landing Gear, you can use the Replacement Aluminum Gearbox #LG-179015 which is compatible with most landing gear,…
view full answer...The replacement landing gear motor you referenced, Stromberg Carlson #LG-142178, is a widely compatible replacement motor that will work with most major brands of 5th wheel landing gear, including Stromberg Carlson, Lippert, Venture and Atwood.…
view full answer...