Filter Products
Filter by Type of Accessory
$27.35 - $28.06
Videos
for Boat Motor Accessories
Help Articles
for Boat Motor Accessories
Expert Answers
for Boat Motor Accessories
The part you referenced 127194TB is a double-lip seal with an inner diameter of 1.274-inches and an outer diameter of 1.983-inches. The available seal nearest to those dimensions that we offer is part #RG06-010, which is a double-lip seal sold as a…
view full answer...A TCM double-lip grease seal number 127194 has an inner diameter of 1.274-inches and an outer diameter of 1.983-inches according to my research. The available grease seal nearest to those dimensions that we offer is part #RG06-010, which is a…
view full answer...Based on my research, the Trailer Hub and Drum Assembly - 8,000-lb E-Z Lube Axles #AKHD-865-8-EZ-K will be a replacement for the 90865 Rockwell hub and drum. Both of these hub and drum assemblies are 12-1/4" diameter, have an 8,000 lb…
view full answer...Typically, when the outside edges of a tire are showing wear its because the tires are under-inflated. The solution is to inflate the tires to the maximum pressure listed on the sidewall. Now if the outside of tires have what looks like gouges are…
view full answer...Surge brakes use a hydraulic actuator to push fluid to the cylinder piston to activate the brake shoes on drum brakes or brake pads on disc brakes. This pressure should only be applied when weight is pushing against the hitch ball, so no pressure…
view full answer...You can get a new brake mounting flange for your axle. The old flange will need to be cut off. The part is #4-44-1. This is designed to fit a 3 inch trailer axle and should be welded in place by a professional. Since you would also have to get the…
view full answer...The Blue Ox systems cannot be moved back that far but we do have the perfect system for you. Take a look at the Reese SC weight distribution systems linked to the right (minus the ones that say Light Duty). These systems have narrow brackets that…
view full answer...We do not have any hub caps that fit trailer wheels. If you were wanting to go with something nicer looking you'd need to replace the wheel with something like the Westlake ST205/75-14 part #WST57FR or any of the other aluminum wheel options…
view full answer...For your Atwood water heater number gc6aa-10e, it sounds like you have either a wiring issue or an element issue. To determine if a replacement is needed you will want to make sure the connections are good to and from your switch. I recommend using…
view full answer...We do have 205/75R14 size radial tires that have a load range of D and a speed rating of at least 81 mph. Out of our available selection I recommend going with the Kenda Karrier #AM10235. This tire has a max load rating of 2,200 lbs at 75 psi and a…
view full answer...I added a photo which shows the location of the heating element of the Atwood Water Heater GC6AA-10E for you. It is item number 17 in the diagram. Atwood does recommend having a professional do the job if you are replacing it due to its location.
view full answer...If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…
view full answer...