Videos
for Backpacks
Help Articles
for Backpacks
Expert Answers
for Backpacks
I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…
view full answer...It would appear that that your 1978 Airstream had the standard 50 degree a-frame style coupler. You can verify this to ensure that the etrailer A-Frame Trailer Coupler #CA-5280-RB will fit correctly on your Airstream. I personally prefer the auto…
view full answer...The standard a-frame coupler degree is 50 degrees but we do have a 32 degree coupler with the part #DM15633-81 but the rear width of it is 9-7/16 inches.
view full answer...Unfortunately, Atwood no longer has the repair kits available. They were bought out and the company that now owns them stopped producing the repair parts you need. I recommend the A-Frame Trailer Coupler - Yoke Latch #CA-5210-B for your replacement…
view full answer...The etrailer A-Frame Trailer Coupler w/ Round Jack Hole #CA-5280-RB uses the standard a-frame angle of 50 degrees. The length from the rear of the coupler to where the coupler meets its narrowest point is approximately…
view full answer...Thanks for all the detailed information! Given the taller height of your 2019 Chevy Silverado 2500, I recommend the 10" rise or…
view full answer...For your 1993 Ford E350 Van the only style of trailer wiring we have is the kind that installs inline with the vehicle taillights like the T-One kit part #118343. With this kit…
view full answer...Thank you for providing the inner diameter of the two bearings; that is especially helpful when trying to determine which replacement parts are going to work. Even though we can confirm the bearings are a fit,…
view full answer...The correct tire chain adjusters for 12x16.5 Skid Steer Tires will be the Titan Chain Multi-Arm Rubber Tire Chain Adjusters part #TCMA2. These fit…
view full answer...When installing the etrailer #e98844 on your 2020 Toyota Highlander, you'll need to scrape the undercoat so that the mounting flange of the…
view full answer...The spare tire for a 2019 Toyota Highlander is stored under the vehicle. If you check out the attached installation video for the etrailer Trailer Hitch Receiver #e98844 you can see the empty location under the vehicle where the spare tire should…
view full answer...In order to replace the hubs/drums on a old mobile home trailer with a 25580 inner and LM67048 outer bearing you can use the Dexter Trailer Hub and Drum Assembly part #8-201-5UC3 which has a 10-10 grease seal which is…
view full answer...