Expert Answers about Buick Rainier

Recommended Weight Distribution for 2005 Buick Rainier Towing 2000 Jayco Kiwi 17A Travel Trailer
For towing your 2000 Jayco Kiwi 17A A-frame travel trailer with your 2005 Buick Rainier I recommend using a weight distribution hitch with integrated sway control, like the Equal-i-zer # EQ37060ET that you referenced, since these systems do more to improve your towing experience than the simple standalone friction sway bars like # 83660. A properly-rated weight distribution hitch (WDH) will not only prevent trailer sway but it will also balance the weight of the SUV/trailer system to keep...
view full answer...

Recommended Fastway Weight Distribution For 2017 Jayco Jay Flight 195RB Trailer
For your 2006 Buick Rainier and your 2017 Jayco Jay Flight 195RB, the Fastway e2 Weight Distribution w/ 2-Point Sway Control - Round - 6,000 lbs GTW, 600 lbs TW # FA94-00-0600 may be sufficient, however, I recommend bumping up to the # FA94-00-0800. This system will give you the same minimum tongue weight, but will allow for up to an 800 lb tongue weight. Based on the specs for your trailer, if you were loaded to capacity you could have a trailer tongue weight of up to 525 lbs, and that...
view full answer...

Is there a Brake Controller Wiring Harness for Elecrical Connection on a 2006 Buick Ranier
Yes, your 2006 Buick Rainier will have a bundle of wires under the dash to the left of the steering column that will need to be spliced to the wiring included with the Tekonsha P-3 Trailer Brake Controller, item # 90195. This installation is the same as the one you saw in the video for the 2004 Trailblazer, and will work for the 2004 - 2006 Rainier with factory tow package. There is not a connector on your vehicle, so the wires must be spliced and the P-3 includes butt connectors for this...
view full answer...

Can the Superwinch LT2000 Pull a 3700 lb Camper up a 10 Percent Grade
Yes, the Superwinch LT2000 Electric Utility Winch # 1120210 would work well for you. As the 2,000 lb rated line pull of this winch can handle 10,000 lbs of rolling weight at a 10 percent incline so you should be more than good. Check out the FAQ I attached that has a chart on rolling weight capacities based on grade percentage.
view full answer...

Parts Needed to Tow Trailer With 2004 Buick Rainier
According to the owner's manual of your 2004 Buick Rainier your vehicle can tow a trailer with a maximum weight of 5,500 lbs to 6,700 lbs depending on your engine and if it is 2WD or AWD; you can find this information on page 4-55 of the manual. According to my research a 2005 Jayco Feather Sport has a GVWR of 3,750 lbs so it would seem you would be fine but you will need to verify all information in your respective manuals to make sure. Your Rainier should have a hitch and factory wiring...
view full answer...

Recommended Bike Rack for 2 RadCity Plus E-Bikes
If you have a RadCity Plus e-bike like the RadCity Plus 5, I recommend the Hollywood Racks RV Rider item # HLY64FR. Apart from the amazing 80 pound per-bike weight capacity, the mounting clamps on the RV Rider are extremely versatile to fit your step-thru style frame with a bike frame adapter bar like the item # 64005. These clamps also avoid any unnecessary risk of damage to your bike's fenders. If you have an extremely wide center tube on your RadCity Plus, you can always use the lowest...
view full answer...

Universal-Fit Towing Mirror Options for 2007 Buick Rainier
The K-Source Universal Clip-On Towing Mirror # KS3891 will fit on just about any mirror that has a gap between the outer housing and the actual glass mirror surface, that gap being where the clips on these mirrors grab onto the housing. If you refer to the photo I linked you'll be able to see how the mirror's arms grip on to the housing at that gap. The linked installation video will also help show you how these mount. This mirror is sold as a single unit, so you'll need to order two to...
view full answer...

Base Plates and Flat Towing Accessories for 2006 Buick Rainier and Blackhawk Tow Bar
From the research I did, you will need a transmission lube pump or drive shaft disconnect to flat tow the 2-wheel drive model. For the all wheel drive model you will have to use a transmission lube pump to flat tow. Be sure to consult your owners manual for the proper towing procedure and anything else that may be needed. Once you have determined what you need for your model, you will need compatible base plates to go with the tow bar. You can use the Roadmaster XL base plates, # 3109-1....
view full answer...

How to Determine if K-Source Universal Towing Mirror Fit 2007 Buick Rainier
Likely but I can't tell you for sure as we haven't done a test fit; but so long as the mirrors on your 2007 Buick Rainier are between 4-1/2" to 11-1/2" tall then yes, the K-Source mirror you asked about will fit: - K-Source Universal Towing Mirror # KS3891
view full answer...

What Vehicles Do the 3109-1 and 194-1 Base Plate Kits Fit
There are several vehicles that each of these base plate kits fit. I have listed each below for you. The Roadmaster XL Base Plate Kit, # 3109-1, fits the following vehicles. Buick Raineer, 2004 - 2007 Chevrolet Trailblazer, 2002 - 2009 GMC Envoy and Denali, 2005 - 2009 Isuzu Ascender, 2003 - 2008 The Roadmaster XL Base Plate Kit 194-1 fits the following vehicles. Chevrolet Malibu, 1997 - 2003 Chevrolet Malibu Classic 2004 - 2005 Oldsmobile Cutlass, 1997 - 1999
view full answer...

How Does the Titan BrakeRite SD Adapter Install, 2009 Chevy Silverado 3500 Duramax
The Titan BrakeRite SD Adapter, # T4845900, is designed to work with the Titan BrakeRite II Severe-Duty Electric-Hydraulic Actuator Kit, # T4835700. From what I have found, the plugs on it and the SD kit are unique so that you cannot plug them into the wrong spot. It is just a matter of finding the correct two plugs to plug it in line. Since the unit is designed to help the brake controller and the actuator communicate, it should go on the set of plugs that lead into the Brake Rite SD...
view full answer...

Parts Needed to Install a Transmission Cooler on a 2004 Buick Rainier With 3600 Stall Converter
My research shows that you will need to add the Derale Snap-In Radiator Adapter Fitting, # D13035, to the Derale Transmission Cooler Kit, # D13504, that you selected, to complete the installation on your 5.3 liter V8 GM motor. This cooler would work fine to help cool the transmission for towing. It sounds as if you are building a street strip application, with a 3600 stall converter, so I would recommend going with a Derale Atomic-Cool Remote Transmission Cooler Kit, item # D13950. This...
view full answer...

Will the Timbren Suspension Enhancement System Help Level my 2006 Buick Rainier When Towing
The Timbren Suspension Enhancement Systems can be a big help in situations like this where the factory suspension works fine, but it needs some help. The Timbren SES will spread the axle load out a bit more and lighten the load on the auto-leveling suspension system. They are also less expensive and much easier to install than other systems available. And since you will be presumably towing the same trailer and load each time, you do not need an adjustable air bag system. The rear axle...
view full answer...

Is The Curt Ball Mount C45900 Available
We do have the part number you are looking for, which is a ball mount that fits a 2" trailer hitch receiver; the exact part you need is the following: - Channel Style Adjustable Ball Mount - 2" & 2-5/16" Balls # C45900 This is an adjustable, channel-style ball mount with up to 5-1/4" of rise and 6" of drop, with a 10,000 lb capacity for the 2" ball and 14,000 lb capacity for the 2-5/16" ball. I have added a link below to a video review for you to check out as well if you'd like to take a look.
view full answer...

What Would it Normally Mean if Trailer Running and 12 Volt Accessory Circuit of Wiring Isn't Active
What you described would indicate that the trailer running lights circuit and the 12 volt accessory circuit of your 7-way are not active at this time. The running lights is most likely a fuse on the vehicle so check there first and for the other circuit it's most likely just a circuit not active as it's not always connected on vehicles. You can activate it with 10 gauge wiring like part # 10-1-1 (sold by foot) with a breaker like part # 9510.
view full answer...