Yes! If you have Yakima JetStream Crossbars installed on your 2002 Audi A4 Sedan with a bare roof, the Thule Pulse M # TH614 can clamp onto the crossbars with no problems. This is because the height and width of the JetStream crossbars are the exact same as the Thule WingBar Evo Crossbars.
If you need a complete roof rack, you need the following components:
- Yakima JetStream Crossbars - Black - 50" Long # Y00425
- BaseLine Towers for Yakima Crossbars - Naked Roofs # Y28TR
- 2 sets... view full answer...
One of the nicest racks we offer that I recommend is the Thule OutWay 2-Bike Rack, part # TH45JV. This rack differs from most racks because it uses 2 rubber coated straps to secure the carrier to the vehicle versus 6 on most racks.
This carrier uses the OneKey system to lock both the rack and the bikes to deter theft.
If you are planning on carrying bikes with alternative frames like kids bikes or women's bikes I recommend using an adapter bar like part # 64005. This attaches between... view full answer...
Thanks for the information. My recommendation for your roof rack to carry your kayaks is the Rhino-Rack consisting of the following:
-Rhino-Rack Vortex Aero Crossbars - Aluminum - Silver - 46" Long - Qty 2 # RRVA118S-2
-Rhino-Rack 2500 Series Legs for Vortex Aero Crossbars - Naked Roofs or Fixed Mounting Points - Qty 4 # RRRLKVA
-Custom DK Fit Kit for 4 Rhino-Rack 2500 Series Roof Rack Legs - Naked Roof # DK208
This combination will give you the best roof rack at the price-point for... view full answer...
There is fascia trimming required to install the Curt trailer hitch part # C11448 that you referenced.
I attached a picture that shows where the trimming will be needed. view full answer...
To carry the bike you sent us a picture of with the Thule Passage # TH910XT you would have to use a bike frame adapter bar part # UB01 since it does not have a horizontal top tube. view full answer...
The best 235/80-16 trailer tire we have for you is the Provider Radial Trailer Tire part # PRG80235. This tire has a 14 ply and load range G rating which is good for up to 4,080 lbs (per wheel). It has a maximum speed of 81 mph and comes with a two year warranty. The reason I recommend the Provider is because unlike most other trailer tire manufacturers, they bake test all of their tires which increases longevity.
I have attached a review video for you as well. view full answer...
For a universal option of a wiring harness for your 2007 Audi A4 Sedan, I recommend the ZCI Circuit Protected Vehicle Wiring Harness w/ 4-Pole Flat Trailer Connector and Installation Kit # 119250KIT. This kit will come with everything you need connect using its zero-contact-interface sensors to capture the signal from your factory wires without splicing into them. It will use a power wire directly from your battery to protect your factory wiring from overload. I've attached an article... view full answer...
I do not recommend the use of a hitch adapter because doing so will reduce the tongue weight capacity of the hitch by 50 percent. For example Curt trailer hitch # C11180 is rated for 200 pounds tongue weight. The use of an adapter will reduce the capacity to 100 pounds. So the combined weight of the bike rack and bikes cannot exceed 100 pounds. The adapter will also increase the amount of stress on the hitch and attachment points on the vehicle.
The only adapter with a rise that we have... view full answer...
The CURT Class I, II, and some Class III trailer hitches require the use of a stabilizer strap, # 18050, in order to be in compliance with CURTs warranty requirements. The strap is meant to relieve some of the stress from the hitch when used for any non-trailer load such as a bike rack or cargo carrier. Other manufacturers do not require a strap.
For your 2010 Audi A4, I recommend the Draw-Tite Trailer Hitch, # DT24950. This is the most popular hitch for your vehicle. I have included a... view full answer...
Yes, we have a hitch available for your 2015 Audi A4 that does not require a stabilizer strap when used with a bike rack. For that you would want the Draw Tite part # DT24950 that has been confirmed as a fit for your vehicle. It is only the Curt hitches that require the straps.
The most popular bike rack we carry that has been confirmed to fit this vehicle is the Swagman XTC2 Bike Rack part # S64670. This rack has a ton of positive reviews from our customers who have tried it. Check out... view full answer...
For your 2020 Grand Design Solitude 310GK that is pre-wired for a Furrion observation system we have the Vision S Wireless RV Observation Camera System w/ Side Marker Light Cameras # FCE48TASL-05 which would be all that you'd need. It comes with the rear and side cameras as well as a 5 inch display that allows you to easily view the cameras and select the different views as needed. view full answer...
For ease of use with your 2015 Audi A4, I recommend going with the Yakima Fullback, # Y02634. The Fullback holds a pair of bikes and includes a straightforward installation process using just four straps instead of the common six like the Thule Gateway Pro, # TH88VR.
The Fullback also includes folding dual arms for simple storage on the days you won't be using it, and keep in mind that even though trunk-mounted bike racks will not allow access to the trunk while they are in use, the racks... view full answer...
For your 2016 Audi A4, I recommend the Hitch Adapter 1-1/4" to 2" Trailer Hitch Receiver with 5" Rise # HT5R. This will give you the additional ground clearance you need but will reduce the tongue weight capacity of your hitch by 50%. You will also need to use the 2 inch adapter on your bike rack. view full answer...
When we measured the clearance needed to install the Thule Helium 2 Bike Platform Rack TH44VR we actually found that from the center of the hitch pin hole to the closest edge of the rack when folded was 5", and when not folded was 12", but Thule's measurement takes in to account 2" clearance to make sure the rack will not contact the bumper.
It will for sure work in the Curt Trailer Hitch Receiver # C11448 on your 2020 Audi A4 with the rack in the unfolded position, but when folded up... view full answer...
The SportRack Semi-custom roof rack # SR1002 will fit your 2002 Audi A4. This roof rack fits many vehicles since it is not a completely custom fit rack.
For a custom fit rack that will fit much better you can use Rhino-Rack roof rack using the following parts:
Vortex Crossbars # RRVA118B-2
Feet # RRRLKVA
Custom clamp kit # DK031
This rack will fit the contours of the roof of your 2002 Audi A4 sedan with naked roof much better than a semi-custom rack. view full answer...
The Curt # C11195 is indeed compatible with your 2013 A4 Allroad. The only modification necessary would be a small hole trimmed in the muffler heat shield, as mentioned in the installation instructions which I've linked. The instructions also mention that on single exhaust-equipped models, there's a plastic underbody panel on the passenger side frame rail that needs to be removed. These modifications are on the underside of the vehicle, and wouldn't be visible from behind.
If you'll be... view full answer...
Yes you can use the Rhino-Rack MountainTrail Rooftop Bike Carrier # RBC035 with bikes that have 700c tires. There's no minimum width tire requirement for this rack. view full answer...
For your tire size of 245/35ZR19 I'd recommend the Konig tire chains part # TH01221102. These are Class S compatible so they will fit well with 13.5 mm of clearance, would install easily, and will provide you great traction. view full answer...
Starting with the trailer hitch I recommend the Draw-Tite Class I Sport Frame # DT24950 for your 2018 Audi A4. This Class I hitch is confirmed to fit your vehicle and will use existing holes in its frame for a no-drill installation. It will provide you with a 1-1/4 inch receiver opening and has a 200 pound tongue weight limit.
I have attached an installation video on the 2017 model A4 that you can use for reference.
Then when choosing a bike rack you will just need to make sure that... view full answer...
We do not have any pictures showing Curt trailer hitch # C11186 installed on an Audi A4. We take pictures when customers leave vehicles here for installations. We have not had that particular vehicle in yet for a hitch installation.
But I can tell you that once installed only the receiver part will be visible. The rest of the hitch will be hidden like in the diagram I have included.
If you will not be doing any towing with the hitch then I actually recommend Draw-Tite trailer hitch #... view full answer...
Go To Results