The only hitch that will fit on the 2011 Audi A4 Avant Quattro Wagon is the Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4" # C11195, which will provide you with a 1-1/4" receiver for carrying a bike rack or light towing. If you don't already have a bike rack, I've gone ahead and linked all of the racks that can be used in the 1-1/4" Class I receiver. view full answer...
The Avant version of the 2003 Audi A4 is the wagon version, so the Curt Mfg. trailer hitch, # 11164, will fit on your vehicle. we have a link to the installation instructions that I attached for you to review.
The Curt Class I receiver hitch is rated by the manufacturer for towing trailers up to 2,000 lbs maximum, fully loaded and ready to travel, and with a maximum tongue weight of 200 lbs.
You will also need trailer wiring. If your trailer has a 4-Way connector the you will use part... view full answer...
I have a solution for you, but the EcoHitch # 306-X7376 is only confirmed to fit on 2018-2020 VW Golf models and not the 2005 Audi A4 Avant. The only trailer hitch we have confirmed for your 2005 A4 Avant wagon is the Curt # 11164, which has a 1-1/4" receiver. If you're planning on towing with this hitch, you'll also need a wiring harness, ball mount and hitch ball.
For the wiring harness I recommend using the ZCI Circuit Protected Vehicle Wiring Harness w/ 4-Pole Flat Trailer Connector... view full answer...
The correct receiver hitch for your 2012 Audi A4 Avant would be the Curt Class I you mentioned, part # 11195. I have confirmed the fit with Curt.
Due to the complexity of the wiring system on your A4 Avant, Curt recommends seeing your Audi dealer for towing wiring harness installation information.
A pin and clip and ball mount is included with the hitch, but you might also need the following:
1-7/8 inch trailer ball, part # 19256
2 inch trailer ball, part # 19258
Locking Hitch Pin, part... view full answer...
To install a brake controller on your 2007 Audi A4 Avant Quattro you would need the Universal Installation Kit for Trailer Brake Controller # ETBC7.
Since you already have a 4-flat connector, you wouldn't need anything else; this kit comes with a 4 pole to 7 pole adapter to make the transition you asked about. Then for a brake controller I recommend the Prodigy P2 # 90885.
This is a proportional brake controller, so when you activate the brakes on your Audi, the trailer's brakes will... view full answer...
The Malone SteelTop Roof Rack part # MPG202 does require factory raised side rails to install; so it will not fit on your Audi A4's naked roof.
If you want more room, or space to mount accessories on the bars I recommend Rhino Rack roof rack system, consisting of part # RRVA118B-2, aero cross bars in black or part # RRVA118S-2 for aero bars in silver, part # RRRLKVA, the Rhino Rack 2500 series legs, and part # DK031 the custom fit kit for your Audi. This roof rack system has 46" long... view full answer...
The Thule OutWay Platform Bike Rack # TH65Jv is confirmed to fit your 2005 Audi Avant. However, it only has a maximum weight capacity of 33 pounds per bike. So I can't recommend using it to carry your two Electra Townie Go! bikes weighing over 50 pounds each. Also, like you said, the top clamps will likely not reach the tubes of the bikes.
Instead I recommend adding a roof rack using the Malone # MPG202. Then you can use two of the RockyMounts BrassKnuckles Roof Mounted Bike Rack #... view full answer...
There is a trailer hitch receiver option for your 2002 Audi A4 wagon, but only a 1-1/4, Class I hitch, as there were no 2 inch hitches ever made to fit this vehicle. So while you can add a hitch, it does have to be the 1-1/4 inch, Class I hitch from Curt:
- Curt Trailer Hitch Receiver # 11164
I recognize this isn't exactly what you were looking for, but it is the only hitch option for your Audi, and it does also require a Class I-compatible bike rack. There are quality options for a Class... view full answer...
Yes, the Thule Circuit TH526XT, will work with the Rhino-Rack Vortex Aero Crossbars, # RRVA126B-2, # RRSX100, for use on you 2014 Audi A4. view full answer...
Sun or moonroofs that do not open up above the vehicle roof line can be opened without any interference with a roof rack such as Thule AeroBlade edge system # TH7602-TH7602. But if the roof does open above the roof line there is an easy way to determine if there will be interference. And this goes for any roof rack for your 2009 Audi A4. You will need one other person and the roof rack.
Place the roof rack in position according to the instructions but do not tighten it down. Start opening... view full answer...
I have confirmed with the manufacturer that the Rhino-Rack Ski and Snowboard Carrier # RR576 will fit your Rhino-Rack without an issue. There will be sufficient usable space on the roof rack crossbar to successfully mount the ski and snowboard rack. This is a really nice carrier that can secure up to 6 pairs of skis or 4 snowboards. view full answer...
The Thule OutWay Trunk Mounted Bike Rack part # TH9002PRO that you referenced is a confirmed fit for your 2015 Audi A4.
The fit tips are:
Place top clips in the gap at the front edge of the top of the trunk, hatch or door.
Place lower clips in the bottom edge of trunk or hatch.
Lower arm of carrier should be positioned on upper tier of bumper. view full answer...
Yes, our Curt Trailer Hitch Receiver # C11448 is the Curt part number 11448. I reached out to Curt as we do not have any of these in our warehouse to confirm the measurement. They informed me the mounting bolt hole measurement is spread 12-1/2" on center for the mounting holes in the trunk area of your 2021 Audi A4. view full answer...
The Curt # C11448 and Draw-Tite # DT24950 receivers for your 2021 Audi A5 Sportback Hybrid are going to mount in the same under trunk locations. While the Curt does only have the one center section the mounts on the Draw-Tite are placed on separate arms with the mounting holes being in the same place on both.
If you are worried about mounting to the trunk drain holes the Stealth Hitches Hidden Rack Receiver # 391AUDA417 is going to be a better choice. This receiver mounts behind the bumper... view full answer...
I have spoken with one of my contacts in Tech Support at Curt Manufacturing, who tells me that the the Class I Receiver Hitch, part # 11186 will not fit the wagon, or Avant model. He confirmed that the receiver you currently have is the only receiver designed for use on that vehicle. view full answer...
I checked with Thule and the Thule Force L part # TH6357B that you referenced is a confirmed fit for the factory crossbars of your 2013 Audi A4 Sedan. This will fit and work very well for you. Thule offers square bar roof rack just like what you have so this was partially designed for that shape of bar. view full answer...
You may be able to have a receiver fabricated using the Weld-On 2" Receiver # E17 as I do not see anyone fabricates a custom fit receiver for your 2008 Audi A4 Quattro Wagon. You will want to contact a fabrication shop in your area and have them inspect your A4 to determine if there is enough structure to be able to fabricate a receiver.
If you are able to get a receiver fabricated I recommend installing the Tekonsha ZCI 4-Way # 119250KIT harness. This uses sensors which are placed around... view full answer...
Unless you have done some modifications that would put your exhaust in the way of the Draw-Tite Sportframe Trailer Hitch Receiver # DT24950 (see attached photo) you should be good to go.
I have also attached an installation video and the instructions for you to reference.
If you let me know what you will be using it for I can make some recommendations for you. view full answer...
Since I don't know the model year of your Audi A4 Avant Wagon I checked several years for trunk-mount bike rack fits. There are many Thule racks that will fit your A4 wagon if it is 2014, 2013 or 2012 and the link provided shows all rack fits that are common to these three model years. One cost-effective option is the Passage 2 Bike Carrier # TH910XT shown in the linked video.
If you have a different model year please advise and I can check again for you, or you can use the link to our... view full answer...
We have a hitch that will fit the Audi A4 Avant Wagon, Including Quattro models. The Curt Class I Trailer Hitch Receiver with Drawbar, item # 11195, is the correct hitch for your vehicle, and I have included instructions for you to review.
The Draw-Tite Class I Trailer Hitch Receiver, item # DT24950, you have referenced is not designed to fit the Audi A4 Avant. It will only fit the sedan model.
Some items you may also need to complete your towing setup are listed below.
Hitch Ball 1-7/8... view full answer...
Go To Results