If you were to use the manual override lever of the Hopkins and compress it all the way it would only put as much power on the brake circuits as you had set the controller to as the max. So if you had it set to 50 percent power it would only go to 6 volts when slid all the way.
This is so that you don't grab the override in an emergency situation and just lock the trailer brakes up and make things potentially worse. Also helps set overall braking strength. view full answer...
You are correct. The Curt wiring harness part # C56209 that you referenced is the correct trailer wiring harness for your 2015 Ram ProMaster 2500 with a 159 inch wheel base. We confirmed this fit with Curt. view full answer...
Yes, we have confirmed with the engineers at SeaSucker that the SeaSucker Monkey Bars Roof Rack - Vacuum Cup Mount # 298-SX6000B does have enough suction power in order to stay mounted to the non-slider side of your Travato RV. If you need straps to secure your SUP to the Monkey Bars, I recommend the Cam Buckle Tie-Down Straps for SeaSucker Monkey Bars - 1" Wide x 10' Long # 298-SA0010. view full answer...
I did some online research and your 2022 Ram ProMaster 2500 is compatible with the Carr Custom-Fit Side Steps - Hoop II - Black Powder Coated Aluminum - 7" Step - 1 Pair, part # CARR105771. Drilling will be required for the installation of these steps. I did some online research and the Carr Super Hoop, part # CAR54GR, does not fit your 2022 Ram ProMaster 2500.
I have included a product description link and a video review link below. view full answer...
I recommend installing the etrailer Trailer Hitch Receiver # e99AR on your 2023 Ram ProMaster 2500 because it has a matte black finish that helps it match the trim on your vehicle plus helps hide scratches better than the classic glossy black finish does.
Then if you don't already have a bike rack in mind I recommend using the Kuat Pivot 2 Swing Away Hitch Extender # PVP20B along with the Kuat NV 2.0 Base # BA22B. This combination was built for the ProMaster and can accommodate a wide... view full answer...
The only white fenders we have that will fit your 15" wheels are the # PF11X35W-2. We also have reports that this was a match for a 2000 Escort boat trailer, so it is likely this is the same part. If you decide you only want to place the one fender we do have a single fender available as well # PF11X35W.
We don't have the same mounting bracket style so you would need the # PF1135-BKT-2. The mounting holes on the brackets are 3-5/8" apart so you would need to acquire U-bolts from your local... view full answer...
The Curt Wiring Harness part # C56270 is designed to fit 2015-2019 Ram ProMaster City. Since you have a 2016 Ram ProMaster 2500 you want Curt T-connector part # C56209. I was not able to find any relays that are related to the function of trailer lights so I do not believe that is the issue here. Usually if a relay or fuse is missing under the hood or in the power distribution box then you would not have power to the trailer lights at all.
If you have the correct T-connector and your... view full answer...
I checked with the manufacturer on this and they were able to tell me that the Advent Air Distribution Box w/ Wall-Mounted Thermostat for Advent Air RV Air Conditioners - White # ACRG15 uses the following hardware:
- 6 qty #8 X 5/8" Phillips Pan head tapping screw
- 4 qty 1/4-20 X 7" serrated flange head bolt
- 2 screw covers view full answer...
The best hitch for your 2022 Ram Promaster 2500 is going to be the Curt Trailer Hitch item # C13207. This hitch is custom fit and bolts to your Ram with included hardware. It has a 2" receiver with a 6,000 lbs weight capacity that can be increased to 7,500 lbs when used with a weight distribution system.
For a wiring harness that controls both your trailer's lights and brakes you will want the Tekonsha Vehicle Wiring Harness item # 22112. This custom fit harness plugs into your existing... view full answer...
Sometimes the manufacturer can make changes to the product without changing the instructions. In this case you may need to hold the button down longer on your Greystone 32" Electric Fireplace with Crystals part # 324-000077. Try both 5 and 10 seconds to see if that makes a difference.
When doing the video on the fireplace I di not recall being able to change the color of the crystals but the intensity of the light that was output from them. When holding the button for 3 seconds have you... view full answer...
Hey Terry, thanks for reaching out!
The Roadmaster Spare Tire Mount # RM-195125 will reduce your tongue weight by 33% and adding an extension will not only increase the movement of the tire at the back of your motorhome, but it will also cut the tongue weight by an additional 50% so it wouldn't be safe to use the carrier in this manner.
For an alternative solution I recommend pairing the etrailer Spare Tire Mount # e98ZR with the Saris Swing Away Hitch Extender # SAR36VR so you can swing... view full answer...
Yes, the VanRug Custom Floor Mat for Cargo Vans - Charcoal Gray - Carpet # VRDP14L that you referenced is a confirmed fit for your 2017 Ram ProMaster 2500. As of yet (August 2017) we have not had a chance to install it on a ProMaster ourselves but you can check out the attached picture for an idea of what it looks like. view full answer...
The Thule Elite Van XT 2 Bike Rack # TH302013 is what you're looking for. This will mount on the rear door of your 2023 ProMaster 2500 and allow you to transport 2 bikes. This has a weight capacity of 42 lbs per bike and is a permanent installation. It also comes with a limited lifetime warranty. view full answer...
The online instructions for the Thule Adapter Kit part # TH308960 are the most current so using the SIKA 221 would be the best option for the rivets. view full answer...
We can help you with a step to make it easier enter and exit your 2017 Ram ProMaster 2500 van.
We offer a variety of handy folding step stools in many sizes that you can view by clicking on the linked page. On the page are filters you can click on to select the step width and depth you prefer and we even have models like the folding Safety Step # SASA-10C-G that offers a 2-inch adjustable height range (in 1/2-inch increments). Despite its generous 19 x 15 size this step's aluminum construction... view full answer...
If your trailer uses electric drum brakes then you do not need a brake actuator-type a-frame coupler like # T4067600. Instead you can use a standard a-frame coupler like # CA-5210-B since your brakes' power will come from the signal carried on the 7-way trailer wiring harness.
You will want to choose a coupler that matches or exceeds the trailer's GVWR, its gross vehicle weight rating. The coupler referenced above is rated for 8000-lb trailers but we have lots of similar a-frame couplers... view full answer...
The Thule Elite Van XT 2 Bike Rack for Sprinter Rear Door # TH302043 would not be the correct rack for your 2019 Ram ProMaster 2500.
The rack that you would want for your 2019 Ram ProMaster 2500 is the Thule Elite Van XT 2 Bike Rack for Ram ProMaster Rear Door # TH302013. Looking at the installation instructions for the # TH302013, it will not work if your spare tire is mounted below the rear passenger window. The spare tire would need to be on the drivers side door for this to fit. view full answer...
Ride quality is something that can be improved with air bags, though I did want to first mention that the part number you mentioned isn't a fit for your 2019 Ram ProMaster; instead, the correct fit is the following:
- Air Lift LoadLifter 5000 Air Helper Springs # AL57233
As far as ride quality, it can be improved by using the # AL57233 to add support to the rear of your ProMaster. If your van is loaded with passengers, and that weight is causing the back end to sag or bottom out when... view full answer...
The angle of the mounting plate for the Curt Trailer Hitch Mounted Spare Tire Carrier # C31006 is odd at first glance, but what it enables you to do is not have to hold the full weight of the wheel off the ground as you mount it to the plate.
With the angle you can basically rest the wheel on the plate and that will make it MUCH easier to mount and remove a wheel. view full answer...
Great question!
You'll need to connect the power wire from your solar panel to the yellow wire on the Redarc In-Vehicle BCDC Battery Charger # 331-BCDC1240D but the ground wire will be it's own ground so that will need to be to your vehicle frame or OEM ground connection.
You can connect to the yellow wire using the MC4 Connector Kit # RED98VR or you can use the 16' MC4 Connector Kit # RED38VR to connect to your solar panel wiring. You'll ground the negative connection and then you can... view full answer...
Go To Results