The Thule Evo Raised Rail Feet # TH710401 that you referenced is confirmed to fit the black raised side rails on your 2014 Jeep Cherokee Trailhawk. There are certain racks that only fit the silver raised side rails on your Jeep (which are bit thinner) but these fit will fit your rails perfectly. On your particular vehicle Thule recommends the 53" WingBar Crossbars in Black # TH711420 or Silver # TH711400 to reach across the roof.
This is exactly the system that I would have recommended... view full answer...
To ensure you get everything you need to flat tow your 2021 Jeep Cherokee Trailhawk I'll go over parts you'll need.
First you'll need base plates, for this I recommend the Roadmaster Direct-Connect Base Plate Kit # RM-521451-5. These direct-connect make connecting and disconnecting from the tow bar a breeze. The removable arms provide a nice clean look for you Trailhawk when not in use.
Next you'll need the tow bar, for this I recommend the Roadmaster Falcon All Terrain, Non-Binding... view full answer...
I recommend the Equal-i-zer Weight Distribution System part # EQ37060ET because of its 4-point sway control design compared to other systems with 2-point sway control. It can be used with your surge brake trailer with pole tongue if you use the adapter part # EQ95-01-5950. The adapter attaches to the trailer's tongue and provides the mounting points for the sway control brackets on the Equal-i-zer. It fits tongues that are 1 to 5 inches wide and 2 to 5 inches tall.
The Equal-i-zer system... view full answer...
The Curt trailer wiring harness part # C56208 that you referenced is a confirmed fit for your 2016 Jeep Cherokee Trailhawk and would not cause any computer errors. I attached an install video for you to check out as well.
This harness installs by plugging inline to the taillight harnesses and using the voltage there as signal wires and then draws the power from the battery wire of vehicle. It bypasses all computer related circuits. view full answer...
For your 2014 Jeep Cherokee Latitude with the raised side rails you can use a Thule WingBar Evo roof rack. You will need the 53 inch bars, # TH711400 for silver or # TH711420 for black, and Evo raised rail feet, # TH710401, to attach the bars to the side rails on your Jeep.
The glass roof would not interfere with the roof rack since it mounts on the side rails. If yours is the type that can open though you would most likely have to either remove the crossbars or adjust them to open the roof. view full answer...
We offer a variety of kayak carriers that will fit your 2014 Jeep Cherokee with factory roof rack crossbars.
A great option for transporting two kayaks is the Thule Stacker # TH830. This unit can transport up to 4 kayaks up to 10-feet in length. Its requires your crossbar spread be 24-inches minimum. The linked video illustrates the features and operation. It includes 1 pair of ratcheting tie downs, 2 straps, and buckle protectors, but for the second kayak you will need additional bow/stern... view full answer...
Yes, the Roadmaster Stop Light Switch Kit, # RM-751471 will install on a 2018 Jeep Cherokee. Please note the installation video I attached walking through the installation steps on a 2018 model. view full answer...
When using the Thule WingBar Evo Crossbars part # TH711420 and the Evo Raised Rail Feet # TH710401 on your 2014 Jeep Cherokee you will have a total of 40 1/2" between the front foot packs and 38 1/8" between the rear foot packs. The entire length of the bar is usable at the 53" mark you are able to connect items both between the foot packs and outside of them. This gives you alot of usable crossbar. I have inked a video on a Cherokee below for you to see the kit.
You are correct that the... view full answer...
The CIPA Universal Fit Towing Mirror # CM11980 requires there to be a gap between your mirror and mirror housing. This mirror has a bracket that slides between the mirror and the housing and then is clamped to the housing from the top.
We have not test fit this mirror on a 2015 Cherokee. Since CIPA says this mirror is a universal fit, they do not release specific vehicle fit information.
I recommend the CIPA Clip-On Towing Mirror # 7070. This mirror attaches to your current side mirror... view full answer...
Before flat towing any vehicle you must review your owner's manual to ensure it is capable of flat towing and what steps need to be taken to get your vehicle ready to flat tow. 2WD vehicles can't be flat towed and have to instead be dolly towed with a dolly like the Demco Kar Kaddy X Tow Dolly w/ Disc Brakes - Tilt Bed Frame - 4,800lbs - Wide Tread # DM9713093.
You'll be able to use the same tow bar on your next vehicle as long as it falls under the weight capacity of the tow bar. I recommend... view full answer...
We do have a selection of nerf bars that fit your 1996 Jeep Cherokee. I like the Aries because there are more options as far as style goes (see below) but none of our manufacturers make anything with the electric lowering or lights - you'll need to find a shop to fabricate something for you in regards to that.
The Aries nerf bars that fit your Cherokee are the Black # AA201000
Attached is a review video for you to check out. view full answer...
The Yakima HangOut # Y02637 will fit a large amount of cars. When you post the rack for sale put in the description to use the fit guide on our website to see if it will fit their vehicle. It will fit 2014 to 2018 Jeep Cherokees and an array of vehicles from a 2018 Dodge Charger to a Toyota Highlander. This rack will fit a large amount of cars, too many to list here. The Yakims FullBack # Y02634 is confirmed to fit your 2020 Jeep Cherokee. view full answer...
It is possible that you can trim the front skid plate enough to work around the Draw-Tite Front Mount Trailer Hitch Receiver # 65009 on your 1993 Jeep Cherokee, but this is not something we have done and since Draw-Tite mentions it needs to be removed it may take a bit of custom fabrication to make it work.
Another option is to go ahead and install the # 65009 and then having a skid plate made to fit around it so you get the winch mounting point you are wanting while also keeping the additional... view full answer...
Yes, we have base plates that are compatible with the Demco Aluminator Tow Bar. All you need is the Roadmaster Tow Bar Adapter # RM-032. This will then allow you to install the Roadmaster EZ4 Base Plate Kit # RM-521447-4 on the 2014 Jeep Cherokee Latitude so that it can be flat towed.
Keep in mind that a complete flat towing setup includes the Tow Bar and Base Plates, Safety Cables, Vehicle Tow Bar Wiring, a Supplemental Braking System, and possibly a High-Low adapter depending on the... view full answer...
I have a solution for you that will let you flat tow your 2014 Jeep Grand Cherokee Latitude with your Roadmaster Stowmaster Tow Bar part # RM-501, but it will require you to use a Blue Ox base plate kit part # BX1136 and then the Roadmaster to Blue Ox Base Plate adapter part # RM-031.
Or you would have to upgrade your tow bar to a set that stores on the tow vehicle like the Roadmaster Falcon part # RM-520.
The EZ4 base plate kits are not compatible with tow bars that store on the towed... view full answer...
I'd recommend drilling a pilot hole that's about half the diameter as the self tapping screws of the Demco Air Force One # SM99243 that won't start. view full answer...
We can definitely help you out with the best base plate for your 2021 Jeep Cherokee Trailhawk. The best option, due to the fact it will give your Cherokee the cleanest look when you aren't flat towing and is a bolt-on installation that doesn't require any drilling, is the following:
- etrailer Invisible Base Plate Kit # e98951
This will fit your '21 Cherokee Trailhawk and give you a start to your flat towing set up. Along with the tow bar you'll also need other parts, including a compatible... view full answer...
The Roadmaster Tail Light Wiring Kit for Towed Vehicles # RM-152-LED requires a 1" hole to install the bulbs into the tail light housing. It does look like you're limited on spacing inside your housing and when I reached out to my contact at Roadmaster he confirmed that we need to go with a different tail light kit for your setup.
I recommend the Universal Hy-Power Diode Wiring Kit # RM-154 if the brake and turn signal are combined on your 1999 Jeep Cherokee Sport, or the Universal Wiring... view full answer...
Your etrailer Invisible Base Plate Kit - Removable Arms Item # e98951 and Roadmaster falcon All Terrain Tow Bar # RM-522 will be compatible.
I've attached some installation instructions to help you install these yourself. view full answer...
It sounds like there is an issue with the 4-way connector on the 1993 Jeep Cherokee since the lights work on the trailer when you tow with another vehicle. The first step is to check that the ground on the 4-way connector on the Jeep has a nice solid ground connection to a clean bare metal surface of the vehicle's frame. You also want to make sure that the pins are free of any corrosion. If you see rust on the pins you can lightly sand it off with a fine grit sand paper. Sometimes if the... view full answer...
Go To Results