Yes! The Draw-Tite Max-Frame Trailer Hitch Receiver # 76268 is compatible with your 2019 Acura RDX and can carry the Thule EasyFold XT # TH903202.
The hitch has a tongue weight capacity of 350 lbs, the bike rack is 45 lbs and has a weight capacity of 130 lbs total. Even if you fully load the bike rack, you will only be at 175 lbs which is completely within the hitch's capabilities. view full answer...
I have good news for you because I took a look and there is one bike rack that meets your criteria - it will fit both 1-1/4" and 2" hitches, and is also rated for use on a motorhome. The rack is one of our most popular and is from Swagman:
- Swagman XC2 Bike Rack For 2 Bikes - 1-1/4" and 2" Hitches # S64650
The XC2 is a rack that our customers love due to the fact it is both economical, high-quality, and easy-to-use (weighing just 25 lbs). It has a 35 lb per-bike capacity so your 20 lb... view full answer...
The American made Curt Class III Hitch Receiver # C95CR is a confirmed fit for all models of the 2022 Acura RDX, including the Advance package. With that said, 19" wheels cannot be stored under the vehicle as the hitch will sit inside of the frame and will take up too much room for it to fit properly. As to the kick sensor, I have never seen one ever be completely negated. You will need to find the sweet spot on either side of the receiver as it will sit in the same place as the sensor.
The... view full answer...
To determine if your 2022 Acura RDX has the 12-Volt Power Provision you have 2 options. First is contacting the service department at your dealer to have them tell you if you have the provision. Otherwise you will need to access the 8-pin connector inside your Acura to see if it has 2 red wires in the factory side of the connector. This connector is located on the drivers side above the rear portion on the rear fender(see image).
If you only have one wire you do not have the provision... view full answer...
Yes, the etrailer Trailer Hitch Receiver # e72AR is a confirmed fit for your 2022 Acura RDX. This hitch is made in the USA, has a bolt-on, no-drill installation and will provide you with a 2" hitch receiver. It also has a nice matte black finish. The 2" receiver is the most common size used for hitch mounted accessories such as bike racks, cargo carriers and ball mounts.
If you plan to do any towing, you can round out a tow package by picking up the T-One Vehicle Wiring Harness # 118804... view full answer...
The Draw-Tite Max-Frame Trailer Hitch Receiver part # 76268 is an excellent option for a 2019 Acura RDX. It offers a custom bolt-on fit and then provides a 2" receiver tube opening. In regards to compatibility with a Thule bike rack, most come with a 2" shank or 1-1/4" shank with 1-1/4" to 2" adapter which would then make the bike rack compatibility. The Thule Doubletrack Pro XT Bike Rack part # TH92BJ for example has a 1-1/4" shank with 1-1/4" to 2" adapter.
If you don't have the 1-1/4"... view full answer...
The Rhino-Rack Universal Load Assist # RR-RUSL fits the following crossbars:
Rhino-Rack Vortex Aero, Euro, and Heavy-Duty crossbars; Whispbar Flush, Through, Rail, and HD crossbars; and Thule AeroBlade and square crossbars
If you have one of those listed bars it would fit and work great for you.
Another option that might work is the Inno Load Assist part # INA453 which fits OEM crossbars like you might have. This would fit all crossbar styles so either way this would be a solution that... view full answer...
The Curt # C95CR, which will fit your RDX, can handle wheels up to 18" in diameter, but not over that. So yes, your spare will be fine as it is a 17" wheel. However, as the regular wheel on your 2022 Acura RDX with the Advance package is 19" and came with 235/55 R19 Continental CrossContact LX Sport tires, which measure 29.2" in diameter, it will need to be stored in the cargo area if you ever have to run the spare tire. view full answer...
With the Hollywood Racks Electric Bike Rack part # HLY84FR you will be able to tilt the rack to give you some access to the rear cargo area, but the rear hatch would most likely not completely open to give you total access.
This rack is designed for electric bikes which are pretty heavy so they didn't make it super long as that would put leverage on the hitch, or allow it to tilt too far as that would make it hard to lift back into place. view full answer...
The Draw-Tite # 75784 will include all the hardware needed to get installed. This will require no drilling or trimming to get installed and will bolt directly to the frame of your 2018 Acura RDX. From here there will be a few parts needed depending on what you will be using the hitch for.
If you will be towing, you will need a ball mount, ball, and pin/clip to hold them in place. Something like the Draw-Tite Ball Mount w/ 2" Ball for 2" Hitches - 3/4" Rise, 2" Drop # DT49MR will include... view full answer...
Correct, the Draw-Tite Max-Frame Trailer Hitch Receiver part # 76268 which is a fit for your 2019 Acura RDX does indeed sit below the rear spare tire. Generally speaking, hitch manufactures will position the receiver tube so it does not stick out past the rear bumper but rather flush to it or just a few inches behind it. Unfortunately, I don't have any specifics for you at this time. That said, after looking at the install photo (attached) of the Draw-Tite hitch on your RDX it appears that... view full answer...
The crossbar of the Curt 13423, which we refer to as part # C95CR is exposed, just like the Draw-Tite # 76268 would be.
I've linked to a photo showing what the Draw-Tite 76268 hitch looks like once installed, the Curt # C95CR would look almost identical. view full answer...
The Curt Trailer Hitch Receiver, part # C13130, is a fit for your Acura RDX. The hitch has a 2 inch by 2 inch receiver opening and has a tongue capacity of 600 lbs. Please note that this hitch has a gross trailer weight maximum of 4000 lbs and and a tongue weight capacity of 600 lbs. This hitch is not designed to be used with a weight distribution system.
The SportRack 3 Bike Carrier, part # SR2403 measures 12-1/4 inches from the center of the hitch pin hole to the back of the upright... view full answer...
There are some measurements needed to determine if Thule cargo box # TH615 will interfere with anything on your 2008 Acura RDX. First, if you install a Thule roof rack then from the top edge of the windshield back along the roof 13 inches is the approximately location of the center of the front bar.
Measure from that point back to any potential obstructions (the antenna or hatch when opened). If the distance you get is greater than 46-3/8 inches then there won't be any interference. If... view full answer...
Yes, the Curt Trailer Hitch Receiver # C95CR will fit your 2020 Acura RDX that has the factory temporary spare tire.
You will want to install one of 2 wiring harnesses for your RDX. You will first need to remove your drivers side rear trim panel to determine which kit you will need. There is a empty 8-pin connector on your wiring harness(see picture).
If the connector has 2 red wires you will need the Tekonsha Wiring Harness # 118800
If there is only 1 red wire you will need Tekonsha... view full answer...
The Draw-Tite Class II trailer hitch part # 36114 attaches to the RDX frame member using two weld nuts on each side. I've linked the installation instructions for you as a reference. As you can see in the provided photo, the receiver tube does extend out quite a bit, this is caused by the vehicle's spare tire being in such close proximity to the rear bumper. If the spare was tucked back in a bit more toward the front of the vehicle, the receiver tube wouldn't stick out so far. Welding the... view full answer...
The Curt Trailer Hitch # C13130 is an excellent option for towing a tear drop trailer behind your 2016 Acura RDX! This features a hidden crosstube so it looks very slick, and the 600 lbs tongue/4,000 lbs towing weight capacities are well over the 150 lb tongue/1,500 lbs towing capacities of your RDX (according to your owner's manual).
To complete your towing setup you also need wiring and a ball mount kit. When I looked up the online owner's manual it stated that trailer brakes and a brake... view full answer...
Your 2009 Acura RDX has a naked roof which means a fit kit is needed to secure a roof rack onto the vehicle. That is the purpose of the clamps you're referring to, and trying to avoid. Some vehicles have pre-drilled holes in their roof for a fit kit to connect to but more common is the clamp style that hooks around the door jamb.
I've attached a help article on roof racks that explains how they connect to different roof styles.
Out of the roof racks that are available for your Acura... view full answer...
Yes, both the etrailer Trailer Hitch Receiver # e24AR and Curt Trailer Hitch Receiver # C13130 would be a fit for your 2014 Acura RDX. Since you're limited on capacity the Hollywood Racks Destination Bike Rack for 4 Bikes # HR4000 would be a great option to haul 4 bikes. This hitch mounted bike rack weighs approximately 47lbs and can handle up to 35lbs per bike. It has straps at each wheel cradle and padded clamps on towers in the middle of the rack to clamp on to the frame of the bikes... view full answer...
I have never heard of a trailer hitch receiver with a pin hole depth of just 3/4" and there isn't a bike rack that is going to work with a pin hole at such a short distance.
I know this isn't the news you were looking for but the best option truly is to get the hitch you have removed and install a new one for your 2019 Acura RDX that has a pin hole plenty long enough to use either the Thule or Yakima racks listed above. You can choose from either a 1-1/4" hitch like you have now or 2"... view full answer...
Go To Results