Cold Air Intakes Specs:
Go confidently though deep water crossings by moving your air intake above your vehicle's hood. Snorkel improves overall engine performance by preventing water and dust from getting into your engine, giving you better air flow.
More Information >Videos
for Cold Air Intakes
Help Articles
for Cold Air Intakes
Expert Answers
for Cold Air Intakes
The PR4 leaf spring which we sell as #e28SR is not interchangeable with the PR4B which we sell as part #e54SR. The springs are different lengths and capacities, with the #e54SR being 25-1/8 of an inch long for a 3500 lb axle and the #e28SR being…
view full answer...Old springs tend to stretch out as they wear out so in your situation you would want to go with a slightly shorter spring like the 25-1/4 inch length which we have in a 4k capacity part #e57SR, 5k with part #e28SR, or 6k part #e78SR.
view full answer...Some newer cars, vans and small trucks, especially those with large, aftermarket tires, may require the use of Class S chains. Class S tire chains are designed for use on vehicles with restricted wheel well clearance. I have attached a photo that…
view full answer...Though I do tend to warn people about the ride getting stiffer when upping the capacity of their leaf springs, you are correct in that you will technically never be fully "unloaded". I do have to mention that this could still happen, but…
view full answer...The bolt holes on the top bracket of the CIPA Universal Door-Mount Replacement Mirrors #CM45000-2 are 3-13/16" apart center to center. I have attached a few diagrams showing the measurements for your reference.
view full answer...There typically aren't any part numbers stamped onto the trailer spindle that can be used for identification. There are however numbers stamped onto the hub most times which can be used for identification. The TDE46210 tells me you have a 3,500…
view full answer...Pulling the wheels and hubs off of your 5th wheel trailer is the best option when trying to identify what wheel bearings and seals are installed. On the back of the wheel bearings there usually is printed a part number like #L44643. With these…
view full answer...The #168233 Double Lip Grease Seal has an outside diameter of 2.332 inches and an inside diameter of 1.688 inches. This seal is not compatible with a AF2527E seal with a O.D 2.312, because, even though the O.D. id very close, the inner diameter of…
view full answer...Yes, the Curt Battery #C52023 is the correct battery for your Curt breakaway kit.
view full answer...Thank you for the measurements you provided and for the photo of your trailer suspension mockup showing the spring components' spacing. As long as your shackles do not hit the trailer frame (you mention 1/8-inch clearance) you should be fine, but…
view full answer...The Durabilt Ratchet Chain Binder #DU32MR will close up 8" from 28-1/2" overall length to 20-1/2" overall length. It is designed to fit chains with 5/16" to 3/8" thick links.
view full answer...You can upgrade the 1750 lb leaf springs to 2500 lb leaf springs. You do want to keep in mind that the ride may be a bit stiffer since you are upgrading your springs to a higher capacity. Like you mention upgrading the springs will not give you a…
view full answer...Filter Products (2)