Hopkins Vehicle Wiring Converter with 4-Pole End - Includes Tester and Connectors
(3 reviews)
Price: $31.16
In Stock
Hopkins Vehicle Wiring Converter with 4-Pole End - Includes Tester and Connectors
Item # HM46155
Retail:$43.35
Our Price: $31.16
You Save: 28%
Will this fit?
To see if this custom-fit item will work for you please tell us what vehicle you'll use it with.
In Stock
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
- All Info
- Reviews (3)
- Q & A (0)
- Videos (2)
- Photos
Hopkins Trailer Wiring - HM46155
- Trailer Connectors
- Vehicle End Connector
- 4 Flat
- Plug and Lead
- Hopkins
- Converter adapts a 3-wire system into a 2-wire system
- Includes
- (1) Circuit tester to help find the correct wires
- (4) Quick splices to connect the wire harness to the vehicle
- Rated at 2.1 amps per function
46155 Hopkins Vehicle Wiring Converter with 4-Pole End - Includes Tester and Connectors
Installation Details
This Product Fits The Following Vehicles
- 2002 - 2004 Isuzu Axiom
California residents: click here
Video of Hopkins Vehicle Wiring Converter with 4-Pole End - Includes Tester and Connectors
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Video Transcript for Hopkins Wiring - Trailer Connectors - HM46155 Review
Today we're reviewing part number HM46155, from Hopkins. This is the vehicle wiring converter with a 4-pole end for your trailer, and it includes a tester and all the connectors. So what this does is, it converts a 3-wire system into a 2-wire system for your trailer. So here's the trailer end of the wiring, and then the other end plugs into the converter itself, like that. Actually upside down, but like that. And then the wiring on the other side of the converter is spliced into your vehicle wiring using the quick splice connector set, are included.
And you don't need to guess which wires power which function on the converter, because it's actually embossed into the back of the converter. But you do need to test your vehicle wiring to determine which wires control which function, so you can match them up. And a tester is included, so you can check your vehicle wiring. Also included are cable ties to secure your wiring, a self-tapping screw for your ground, which always gets connected to a clean, unpainted metal surface, some Dielectric grease for your electrical connection, and a dust cap for your 4-pole to protect it when it's not in use. And there you have it for part number HM46155, the Hopkins vehicle wiring converter with a 4-pole end.
.
Customer Reviews
Hopkins Vehicle Wiring Converter with 4-Pole End - Includes Tester and Connectors - HM46155
Average Customer Rating: 3.7 out of 5 stars (3 Customer Reviews)
by: Chris D07/23/2012
Harley Davidson
This is the perfect solution for the Harley Davidson 5 wire harness, easily lets you convert to 4 pin and stores away when you don't need it.
by: Jack06/01/2019
The product did not work and I have to order another that will work.
by: NORMAN08/15/2020
3
3
See what our Experts say about this Hopkins Trailer Wiring
- Troubleshooting 4-Way Wire Harness installation On 2009 Cadillac SRXThe wiring harnesses and kit, part # HM48895 and part # HM46155 you referenced in your question are not designed to be a fit for your 2009 Cadillac SRX. If you find that you have the correct wire harness for your SRX you can check the wiring to make sure all of the wires have been connected as the instructions state. Also, you will want to make sure the ground wire has been secured to a clean bare metal surface. Loose or corroded grounds can cause some of the same problems you described....
view full answer... - Does the Red Wire from the Hopkins Vehicle Wiring Converter Need to Be Wired InYes, you will need to wire in the red wire from the Hopkins Vehicle Wiring Converter # HM46155 to the stop light circuit of your vehicle. Otherwise you will not have brake lights on your trailer. Check out the video I attached that shows how this product would install onto a similar vehicle. Basically, you will use the included circuit tester to find the correct circuit to tap into, and then use the quick-splices to tap into that circuit.
view full answer... - Fuses Keep Popping on 2000 Honda Shadow Ace Tourer When Using the Hopkins # HM46155 to Tow TrailerYour fuses keep popping on your 2000 Honda Shadow Ace Tourer because the trailer is drawing too much power on those wiring circuits. What you need to install is the Curt # C59236 which is like the Hopkins # HM46155 that you installed except the Curt draws power directly from the battery. The wires that connect to your light circuits just tell the unit when to send signals to which circuits. Since it is drawing power directly from your battery it will not overload the circuits on your...
view full answer... - Trailer Lights Go Out When Using Brake Lights and Turn Signals or Running Lights at the Same TimeThis sounds like a ground issue or a potential overload situation. Ground problems normally show up when there is more draw on a system such as when you have the running lights on and then use another function like a turn signal or brake light. And overload could be the result of a short or too many lights on a trailer. Make sure that the vehicle side and trailer side connectors are clean and free of corrosion inside and out. The main connector grounds should be attached to clean and corrosion...
view full answer... - Does Hopkins Vehicle Wiring Converter Fit 2002 Toyota AvalonThe Hopkins wiring kit is a universal harness so it will work with your 2002 Toyota Avalon, with the part number being the following: - Hopkins Vehicle Wiring Converter with 4-Pole End # HM46155
view full answer... - Hopkins Wiring Harness for 2003 Ford Crown Victoria P71Both the Hopkins # 46255 and # HM46155 Wiring Harnesses that you referenced will technically work on your 2003 Ford Crown Victoria P71 but the better option is with the # 46255. In addition to the powered converter that's needed to both combine the separate signal circuits on the Crown Vic to be compatible with trailer wiring and provide sufficient power to the trailer lights, it also includes a fuse holder and fuse along with additional wire to run the converter's power lead up to the...
view full answer... - Which Wires to Use to Install Hopkins # HM46155 Vehicle Wiring Converter on a 2005 Mercury SableIf there are multiple wires that are carrying the correct tail light signals, it would be okay for you to use any of them as long as no other functions are ran on the same wire. I attached a video of this product being installed onto a vehicle that you might find helpful.
view full answer...
Do you have a question about this Trailer Wiring?
Info for this part was:
Expert Research:
Michael H
Expert Research:
Jameson C
Updated by:
Alexander C
Updated by:
Carrie F
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Product Experts Available Now!
Call 1-800-940-8924
Mike L.
6/3/2019
If you could provide us with some specific information about how the harness isnt working, wed be happy to help you troubleshoot. Ill also link you to a help article that will assist in troubleshooting.
Helpful Links
faq-4-5-way-troubleshooting.aspx