To see if this custom-fit item will work for you please tell us what vehicle you'll use it with.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.
Plug in this custom harness and get turn and brake signals on your towed car with no hardwiring or splicing, and no effect on your warranty. The built-in diodes protect your car's electrical system from feedback.
Features:
Notes:
A combined lighting system, or 2-wire system, uses the same light bulb to signal both braking and turning. (In other words, the car signals a turn by flashing the brake light.)
A separate lighting system, or 3-wire system, has the brake signal and the turn signal light up independently of each other. Typically, the turn signal is amber.
To keep the separate lighting system on your car functioning properly while you're flat towing, add a wiring converter (118158 - sold separately) and 2 additional diodes.
If the engine is off and your car's brake lights illuminate when you press the brake pedal, you need to install a brake light relay (RM-88400 - sold separately) with this kit. Without a relay, your car's brake signal will override the turn signal sent by the RV when you are slowing down to make a turn, creating a potentially dangerous situation. Other drivers will see that you're slowing down, but not that you're making a turn. With a brake light relay, you can signal both and travel safely.
Average Customer Rating: 5.0 out of 5 stars (6 Customer Reviews)
Plug in this custom harness and get turn and brake signals on your towed car with no hardwiring or splicing, and no effect on your warranty. The built-in diodes protect your car's electrical system from feedback.I chose not to follow the etrailer video installation for this because I did not want to cut holes in the factory grommets. There is plenty of room to run the wires under the rear bumper cover. Hardest part is running the 4 pole connector back to the front of the vehicle. The Focus is very low and without a lift, its a challenge. It is also nearly impossible to run the 4 pole wires to the middle of the vehicle with the front bumper cover on after the tow bar has been installed. I tried for about 30 minutes before giving up and taking the front bumper cover off again.
Why pay $225 for this item at the base plate company, This item fit perfectly, has a great install video and is 1/3 the price!!!
The customer service representative was knowledgeable about the product.
Easily installed works great.
It was a breeze to install! Working great so far.
Very Good Service - Good Pricing
Do you have a question about this Tow Bar Wiring?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Ken K.
11/12/2017
Thank you for supplying the product and the video. The video was quite helpful.