Replacement Motor Solenoid for Fisher Snow Plow - 100 Amp - Continuous Duty

Video Transcript for Review of SAM Snow Plow Parts - Snow Plow Replacement Parts - 3371306400

Today we're gonna take a quick look at the replacement motor solenoid 100-amp continuous duty for Fisher snow plow. This is going to replace that important motor solenoid for your Fisher snow plow, it's gonna be a connection point between our plow and our battery to help prevent any overloads or any issues with our vehicle or with our plow.You'll get the solenoid bracket itself, and then a jumper wire. This you might not need depending on your setup. If you have the cable-operated hydraulic system you will need to connect one end of your jumper to one of the posts down here, and then up to the top. But if you have the solenoid valve hydraulic system, you won't need that. It does come with instructions to show you how that's supposed to be hooked up there depending on which system you have.As far as dimensions, our solenoid is going to be about 3 1/2 inches tall going from the bottom of the bracket to the top of that bolt.

The solenoid itself is gonna be about 1 1/2 inches wide. Our bracket overall is gonna be three inches wide. From the center of the attachment hole to the center of the other one it's gonna be about 2 1/8 of an inch. But you will have about 3/8 of an inch of play there, that's about how far apart that is. Front to back it's gonna be about 2 3/4 of an inch, or 2 1/4 inch wide.Our jumper wire overall is gonna be about five inches long, and you will wanna note that one of our ring terminals is gonna be larger than the other.

If you do need to use this, the smaller end will go on the bottom, and the larger ring terminal will go up to the top. But again, you might not need this for your setup, basically you're just gonna replace your old solenoid with the new one, exactly how the old one was set up.That's gonna do it for our look at the replacement motor solenoid with 100-amp continuous duty for Fisher snow plow.