Summer Starts Here - Save up to 70%
This portable hand grip gives you an extra handle for leverage where you need it. It attaches to glass, fiberglass, metal, and most plastics with (2) 4.5" vacuum cups and it only takes seconds to install and remove. Supports up to 240 lbs.
Features:
Specs:
This vacuum cup-mounted handle gives you an extra grip wherever you need it. Mounts to most glass, fiberglass, metal, and plastic surfaces. Use it as a handle to lift yourself onto your boat, to sturdy yourself while getting into your shower, or as a paddleboard or kayak carrier.
This handle is quick and easy to mount. To install the handle make sure the mounting surface is clean and place the vacuum cup on your non-porous surface then press the pump several times until the orange band disappears. To break the seal and remove the handle from simply pull the T-shaped tab up and towards the center of the cup. As suction decreases over time the plunger will extend from the cup. When the orange indicator band shows simply re-pump the plunger.
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
Speaker 1: Today, we're going to be taking a look at the SeaSucker handle, part number 302-5280. This handle has a 200 pound weight capacity, and it's great for wherever you need a temporary handle, like my paddle board here. It's also great here at the entrance to my RV. The two 4 1/2" cups provide a firm grasp. As you can see, it's not going anywhere. It's made out of a starboard construction.
It's rugged and durable.Now that we've gone over the features, I'll go ahead and show you how to get it installed. First thing you want to do, is make sure that the surface you're mounting it to is clean of any dirt or debris. Then, you want to moisten the bottom of your vacuum cups. I've already done mine. Then, we can put it in place.
Now, you want to be sure you stay away from any paint chips or any seams. Once it's in place, we can apply some pressure, and then begin depressing the pump cylinder until the orange band disappears. Then, we're all set.Now over time, if the orange band reappears, no problem. Just depress the pump cylinder until it disappears, and you're all set to use it again. Also included is multi-purpose lubricant sealant.
This is to help maintain your pump cylinders. Just put a little bit around the edge here, and depress it several times until it works its way in. Then, you're all set. It's very easy to remove. Just push in on one of the T-tabs, on either side of the cup, and it comes right off.
It also comes with two covers, so you can protect your vacuum cup while in storage.That's going to complete our look at the SeaSucker handle, part number 302-5280.
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.