Replacement Oval Vacuum Pad for SeaSucker Bike Racks - 3-1/4" - Black

Video Transcript for SeaSucker Bike Racks Replacement Oval Vacuum Pad Review

Hi everyone, it's Evangeline here at etrailer. And today we'll be taking a look at the replacement oval vacuum cup for your SeaSucker accessories. This can be used with your Ridge Ready roof rack or if you need to upgrade your round cups on your monkey bars, you can use this too. This is going to be an exact replacement for your oval vacuum cups. So this includes the vacuum cup as well as the plastic cover. This will not include the vacuum plunger or any hardware, so you will have to find those separately here at etrailer if you need to replace them.

This is going to be 3 1/4 inches wide by 7 1/2 inches long. So for width, it's less than your round vacuum cups, but for length, this will take up more space. So if you're ready to replace or upgrade your vacuum cups, grab your flips head screwdriver, and let's get started. Now, if you have the monkey bars installed you might need a smaller flips head or you'll take off the whole bar, but you just need to get access to those four screws. Loosen the screws until they all come off.

Then your setup will just pop right off. Don't forget to remove the vacuum cup too as you have this little tab on the inside you need to lift up, and just like that your cup is released. Most of your SeaSucker kits come with an extra plunger, so I would just go ahead and switch out your old plunger while I'm at it. Put that on your new vacuum cup and reinstall this the exact same way you took your old vacuum cup off. Don't forget to tighten all of them down securely.

This will be the same process for switching out your round cups for the oval cups, although make sure you switch out all of them too. And that right there was a look at the replacement oval vacuum cups for your SeaSucker accessories.