Large UTV rearview mirror clamps around the rollcage on your UTV and provides excellent visibility of what is behind you.
Features:
Specs:
Videos are provided as a guide only. Refer to manufacturer installation instructions and specs for complete information.
All right today in this 2014 Polaris Ranger Crew 570, we're going to install Part #CM-99287. This is a CIPA extra large UTV rear view mirror. A couple of things to know about this mirror, it has a wide angle convex mirror, it has an aluminum bracket that will resist corrosion and the mirror face measures 3 7/8 inches tall by 10 3/4 inches wide and fits roll cage diameters from an inch and three-quarters to 2 inch. As you can see as we install it, this is designed for a UTV without a hard top. All right to start off our install, we're going to go ahead and loosen up the windshield that's on our vehicle. We're just going to loosen up some of the hardware just to give us some working room then we'll put it back when we're done.
Now, all this does is clamp across the top bar so go ahead and take the clamp apart and completely remove the two screws. Then we'll take one half of the clamp and put it behind the bar. We'll let the windshield help us out by holding it in place while I install the other half and then install the screws. First we'll go ahead and install the top one to help hold everything together, then we'll rotate the mirror so we get access to the other screw. All right, once we have it loosely installed, we'll go ahead and rotate it to the position that we want and then we'll go ahead and tighten down the screws for good.
Now once we have our mirror in place, we'll go ahead and re-install the windshield. And in just a few moments our mirror is already installed. And that will finish it for the CIPA extra large UTV rear view mirror, Part #CM-99287, on our 2014 Polaris Ranger Crew 570. .
Average Customer Rating: 4.0 out of 5 stars (4 Customer Reviews)
Large UTV rearview mirror clamps around the rollcage on your UTV and provides excellent visibility of what is behind you.The mirror is large, BUT, the bracket was too small to fit the 2" top front roll cage bar on my Kubota RTV. After sanding down the inside of the brackets (making the diameter a bit larger), I finally got it to fit the top right side support, but the position is awkward. This mirror will NOT fit a 2" roll cage.
Got this to fit on my new Titan Scout E2 and it is great. I had to lift the factory top (4 bolts) to install the mirror clamp onto the roll bar but no problem.
My review mirror safe and sound and was on time! I installed on my UTV in minutes. It will be very nice being able to see behind me when driving my UTV.
good fit
Do you have a question about this ATV-UTV Mirror?
Info for this part was:
At etrailer.com we provide the best information available about the products we sell. We take the quality of our information seriously so that you can get the right part the first time. Let us know if anything is missing or if you have any questions.
Thank you! Your comment has been submitted successfully. You should be able to view your question/comment here within a few days.
Error submitting comment. Please try again momentarily.