CE Smith Boat Trailer Roller Bunks Water Test Video

The Dutton-Lainson Roller Bunk Bracket, part #DL21742, fits Dutton-Lainson Roller Bunks #DL21740 and DL21741. Four are needed to mount a pair of roller bunks. My contact at Dutton-Lainson advises that u-bolts are not specifically required to install…

The Boat Trailer Roller Bunk Brackets #DL21742 do require 7/16" U-bolts such as #7163183UB. The bunk brackets are designed to be used with Roller Bunks #DL21740 or #DL21741.

You can use roller bunks like the Dutton-Lainson Boat Trailer Deluxe Roller Bunk - 5' Long Sections - 12 Sets of 3 Rollers #DL21741 instead of carpeted bunks on your 2012 Deep V Tracker boat without any marks or indentations. The roller bunks…

I would place the roller bunks in the same orientation as the wood bunks that were there previous. There would be no need to extend them out further. Normally the bunks extend just a bit past the rear of the trailer frame like the picture I…

I went out to the warehouse and pulled a roller bunk bracket #DL21742 to measure the slotted hole spacing for you. The slotted holes are 1-1/4 inches apart on center. I also made a short video showing this measurement for you.

The CE Smith Roller Bunks for Boat Trailers part #CE27710 are 5' long so as long as these are close to the same length of the bunk boards you have on your trailer now they will work well for you. The CE Smith Roller Bunks for Boat Trailers are is…

Thanks for the great picture! Sorry to hear you're having problem with the 1,500 lbs CE Smith Roller Bunks Item #CE27710. It sounds like they are overload so let's get you upgraded to the Dutton-Lainson Boat Trailer Standard Roller Bunks item…

The CE Smith Keel Roller Assembly for 2-Inch Wide Trailer Tongues, part #CE32005G, has multiple mounting holes to allow it to fit on a 2-inch trailer tongue at any of 4 or more different heights depending on how it is oriented. Please refer to the…

For the Roller part #CE32100G that your referenced the distance from the mounting surface up to the top of the roller measures 3-5/8 inches. The roller part #CE32150G that you referenced instead measures 3-3/8 inches.

I went out to the warehouse and pulled a Offset Spool Roller Assembly, #CE32150G. Measuring from the bottom of the base to the top of the roller in the center section it is 3-3/8 inches. From the bottom of the base to the taller part at either end is…

As shown in the brief video and photo that I have prepared for you, the height of the rubber spool roller's center portion above the bottom of the frame on the CE Smith Spool Roller Assembly #CE10400G is 8-inches to the center of the roller and…

Bunk rollers like the #DL21754 you mentioned would be an excellent choice for PWC's that rest on the edges of the bunks, as most of them do. At 4 foot long, they'd probably offer plenty of support, but I'd recommend getting a set…