Review of CURT Adjustable Weight Distribution 2 Inch Shank - C17100 Video

The best practice is honestly to replace tires in pairs. That way they should wear at the same rate and they'll be on the same replacement rotation. This being said, if the tires on that axle were still pretty new (a year or less old) and…

Yes the Curt weight distribution shank part #C17100 is perfectly compatible with the Fastway e2 weight distribution system you have.

Yes, radial tires are much preferred over bias ply tires for a number of reasons. The main difference between a radial ply and a bias ply tire is how the tire is constructed. The cords inside a bias ply tire run at a 32 degree angle to the direction…

If your current awning is a 16 foot awning you can use this replacement #LCV000334402. This is compatible with Solera, Dometic A&E, and Carefree of Colorado awnings. Dometic A&E make the Sunchaser Awning Model #834AV18.401

To find the correct rise or drop what you need to measure is the from the ground to the top of your hitch receiver opening, which it sounds like you have done and got 25-1/2". You also need to measure from the ground to the bottom of the…

Any weight distribution shank, including the Curt Welded Weight Distribution Shank 7" - 10 Hole Adjustment #C17123, being only 4 to 5 inches off the ground is possibly concerning when going over steeper inclines such as up a driveway or a…

I am not aware of any legally mandated minimum ground clearance requirement for trailer hitch receivers in any states and my online research did not reveal any such laws. However, I did find on an internet forum for Sienna owners posts related to…

Trailer brakes that lock up can be related to several problems. If they lock up when the trailer connected is connected that would indicate that the 12 volt accessory circuit is shorting out to the brake output circuit on the trailer which is causing…

Sounds like there could be a short in your trailer wiring for one of the brakes or there could have been a mechanical failure in that one brake assembly. The second possibility is more likely since only one brake was affected. First inspect the…

There are a few things you can check to make sure the brakes are adjusted correctly, but it sounds like there may be a short in the system. I would start by checking the trailer wiring connector on the truck and trailer for corrosion. If there is…

One wheel locking up on your trailers brakes could be for a few reason. Most likely it's due to a brake assembly that is out of adjustment. You want to adjust the assemblies so there is only a light drag on them when they are turned by hand.…

Based on the picture you attached I believe you have a Husky Round Bar Weight Distribution System, for which the correct replacement head is part #HT31516. Typically the only component of a weight distribution system that's interchangeable…