Mighty Cord Replacement 7-Way Trailer Connector Review Video

A vehicle 7-way harness will have a locking tab of some type to ensure the wiring harness remains connected to the socket. This is an important safety feature for maintaining all of the trailer signals but especially so for the power to the trailer…

The light that indicates that the 12 volt circuit is hot is normal and it will not drain the battery. Think of it as the battery having a really long positive terminal that just extends to the rear of the vehicle. If nothing is drawing power from it,…

I contacted our representative at CURT about the CURT Front Mount Trailer Hitch #31322. He informed me that the distance from the center of the hitch pin hole, to the front edge of the bumper measures approximately 7 inches. We do not have a Hidden…

We carry a front hitch for your 2010 Chevy Silverado 1500 for that you would want, part #65052. This hitch has a line pull capacity of 9,000 lbs and a tongue weight capacity of 500 lbs so as long as you stay under that you will be just fine.

Installing the Roadmaster 2nd Motorhome Monitor/Alarm Kit #RM-98850 referenced in your question on the Entegra Aspire will require the same process you took for your 2017 Bounder RV. To install the unit, you will need to locate the brake switch wire…

Yes, the second wire will need to be grounded to complete the circuit for the LED Clearance Light, #MCL36AB. If your trailer connector has a ground wire that is connected to the trailer frame at the front of the trailer, you will be able to just…

We have just the lens you are in need of. You'd want the part #A32AB which matches what you sent in a picture of.

You will need direct access to the zerk fitting to fill the hub with grease. If there is a rubber cap in the way like #DC-RP, then you will have to take it off, fill the grease, and then replace the cap. I have included a link to our FAQ article on…

The Roadmaster Even Brake monitor looks like it needs replacing based on your photo. We don't have anything short of the replacement monitor to ensure proper function when the wiring is frayed. The replacement you will want is the Roadmaster Even…

To mount your 7-way wiring harness I recommend using the Draw-Tite Bracket, part #18138. I have attached a photo of the #18138. You can check the mounting holes on the trailer hitch to make sure they will match the mounting holes on the bracket and…

The 7-way bracket part #18138 is a standard 7-way bracket so for a 7-way that fits your 2017 Nissan Pathfinder the replacement 7-way socket is the part #A10-7072VP.