Dexter Replacement EZ Lube Drive-In Grease Cap Review Video

I was unable to find a cross reference for the number 41i you said is on the grease seal on your homemade trailer. I have attached a drawing that shows where you can normally find the numbers on seals bearings and races. You may need to use a…

The ALKO 4,400 lb axles use the same bearing sizes as the standard 3,500 lb alxes. If you want USA made bearings, I recommend the Bearing Kit #TMK52VR. This kit comes with the Timken brand bearings which are all made here in the USA.

I checked with Lippert and could not find any information on NV304664. Do you know the capacity of the axle? If it is a 7,000 pound axle then the likely inner bearing is #25580 and the outer bearing is #14125A. If a 2-1/4 inch seal diameter is needed…

The Lippert 4,400 lb axles use the same bearings and seals as a Lippert 3,500 lb axle so you can use the Bearing Kit for #84 Spindle part #BK2-100 or just the Grease Seal part #RG06-050.

The Camco RhinoFLEX Sewer Hose part #CAM39761 that you referenced uses standard RV sewer connections like what Valterra would have. On the RV side (the side that would attach to a Valterra fitting) there is a bayonet fitting which is an industry…

We have the exact seal you would need. For a pair you would want the part #RG06-050. This is a double lip seal that would work great for you. Double lip seals aren't only for EZ lube spindles. They are just basically a better sealing design than…

The only difference between the Grease Seal - Double Lip - ID 1.719" / OD 2.565" - for 3,500-lb Axles #58846 and the Grease Seal - Double Lip - ID 1.719" / OD 2.565" - for 3,500-lb Axles - Qty 2 #RG06-050, is that the RG06-050…

Bearing Buddies are covered by a lifetime manufacturer's warranty that would cover the replacement of the Bearing Buddies if they were defective, but not new bearings. I would refute what your mechanic tells you, however. I've seen countless…

First, make sure that you have the correct size Bearing Buddy. It should be slightly larger than the hub bore though it is difficult to tell just by looking. If you can tell me the outer bearing number I can determine which is the correct model.…

Thank you for all of the info. The correct replacement bearings would be the part #TMK79FR and #TMK29FR which are both USA made Timken bearings.

I confirmed with my contact at Dexter Axle that the grease zerk used in their EZ Lube spindles like #TRU74FR is a standard 1/4-inch pipe thread fitting that you can replace with an item like #Gzerk. Your local hardware store may have one too. You can…

Yes, the Timken Bearing Kit #TMK52VR will fit your 3,500 lb axle as it fits an standard #84 spindle. The only time this kit won't fit with a 3,500 lb axle is if the trailer/axle is made before the 2000's since that's about the time that…