Curt ATV Towing Starter Kit Review Video

We haven't had the opportunity to install the Curt Trailer Hitch Receiver #C29VV on a 2023 Lexus RX 350 as of yet (December 2023), but I'm attaching a clip from the instructions for you to reference. This part of the instructions…

The ARK #ORJW500D Off-Road Swing-Up Jack weighs in at about 32 lbs. The fully retracted length from the center of the pivot the the bottom of the wheels is 11.22 inches. The same distance when fully extended is 18.89 inches, as you can see in the…

For your 2012 Ford E-350 Econoline Van you can use a step like the Carr Custom-Fit Side Step #CARR124031-1 which will be a 5" wide step. If you are wanting a step for the driver and passenger side you can get the Carr Custom-Fit Side Steps…

When fully retracted, or collapsed the jack is 28.58 inches tall, and 38.42 inches tall when extended as shown in the provided diagram. I've linked you to a product description video featuring the #ORJW1SU ARK Extreme Off-Road Ratcheting…

The Extreme Off-Road Ratcheting Trailer Jack part #ORJW1SU has a 770 lb weight capacity which means so long as the tongue weight of the trailer does not exceed this then you'd be fine. A trailer with GVWR of 4,000 lbs would be no worry at…

The ARK #ORJW1SU Off-Road trailer jack will need about 21-3/4 inches of available space on the trailer tongue. I wasn't able to make out the dimensions on your tape measure in the photo, so I couldn't say judging by that if…

With the ARK Xtreme Off-Road Swing-Up Jack #ORJW500D in its lowest position it is 6.49" from the center of the mounting point to the top of the jack. The other end of the jack when fully retracted is going to be 18.89" from the…

When the Extreme Off-Road Ratcheting Trailer Jack w/ Wheel #ORJW1SU is in the forward position the wheel can move only one direction and it can keep moving forward without the handle moving it. It wouldn't roll back if in forward but if you…

The Xtreme Off-Road Ratcheting Trailer Jack w/ Dual Wheels #ARK54FR will hold in place when pushing up the slope. If you're going down the slope the mechanism will not hold it is place, as the wheel is designed to free spin in the direction…

The mounting plate of the Extreme Off-Road Ratcheting Trailer Jack w/ Dual Wheels #ARK54FR is steel so you could weld it to your trailer frame. There isn't a version of this though that has a smaller mounting base/bracket.

I spoke with Ark and they told me that the Extreme Off-Road Ratcheting Trailer Jack w/ Dual Wheels #ARK54FR stick out 9-1/2 inches from the trailer frame it attaches to.

To install a hitch receiver on your 2004 Honda Rincon 650cc ATV you can use the Curt ATV Ball Mount Adapter with Welded D-Ring #C45006 which installs by bolting on to the tongue of your ATV. This will give you a 2 inch receiver and a D-ring for any…