WeatherTech Side Window Air Deflectors Installation - 2019 Ram 1500 Classic Video

I checked with B&W and yes, the gooseneck hitch #BWGNRK1320 does work with RamBox models of the 2020 Ram 2500. You do want to be careful of clearance issues with the trailer and bed rails though since the bed isn't as wide.…

The B&W Turnoverball Underbed Gooseneck Trailer Hitch w/ Custom Installation Kit #BWGNRK1320 and Custom Underbed Installation Kit for B&W Companion 5th Wheel Trailer Hitches #BWGNRK1320-5W are exactly the same. They are just titled…

The AirBedz Rear Seat Air Mattress for SUVs and Full-Size Trucks, #AB59FR is a confirmed fit for the 2020 Ram 2500 but it is not specialized to that specific arrangement.

The Thule Motion XT Rooftop Cargo Box - 18 cu ft - Titan Glossy #TH629807 should fit your 2020 Ford Expedition, but there are a few measurements you should take to verify. This cargo box fits roof racks that have a crossbar spread between…

Yes, the Thule AirScreen Fairing #TH82WV is compatible with the Yakima JetStream crossbars. The fairing is compatible with aero-style bars that are no more than 3-1/4" long x 1-1/8" tall. Since the JetStream bars measure 3-1/8" wide x…

If you don't have brake or turn signals on the right side of your trailers then the most likely cause of this issue is just a blown fuse, F81 in the engine bay fuse box which is a yellow 20 amp. If the fuse is good then check the wiring behind…

Going by the colors that you mentioned, it sounds like you have the typical set-up, green wire for right turn and brake, white wire for ground, yellow wire for left turn and brake, brown with green wire for right side running lights, and brown with…

I recommend moving away from the Adapter 4-Pole to 5-Pole Trailer Wiring Adapter #47515 and going with a Buyers Products Trailer Connector Adapter #337TC1474P. The wiring and connectors used on the 4-way harness are not designed to be used with the…

Connecting the brown running light wire in standard 4-pole wiring to both tail lights will require a jumper wire from one side of the trailer to the other, or you can install what's called a wishbone harness that has dual brown running light…

Did you have a 4-pin connector that had 5 wires or was it a 5-pin connector? There is a big difference since you normally see a 5-pin connector on a boat trailer with the 5th pin used for an electric reverse lockout solenoid on a brake actuating…

The standard 4 Flat will have the White (ground), Brown (running lights), Yellow (left turn and brake), and Green (right turn and brake). Black will typically be used for 12 volt power, but can also be any number of things. The only way to know for…

A vehicle end wiring harness using a 4-Way Flat connector should have 3 female plugs and 1 male pin. A matching 4-Way Flat trailer connector would have 3 male pins and 1 female plug like on the Mighty Cord Adapter 4-Way Flat to 6-Way Round, part…