Timbren Rear Suspension System Installation - 2010 Chevrolet Silverado Video

The first thing I recommend doing is checking out the max towing and payload weights for your 2004 Chevy Silverado. These can be found in the owner's manual and I do not recommend exceeding them as that can cause premature wear to your suspension…

I reached out to my contact at SuperSprings and the correct SumoSpring for your 2002 GMC Sierra 1500 Denali with Quadrasteer is the SumoSprings Solo Custom Helper Springs - Rear Axle #SS95MR. This will give you 1400lbs of load leveling support when…

Per the instructions for the Timbren Suspension System, part #TGMRCK25S, on medium and heavy-duty trucks there will be constant contact and the system will have no gap. It sounds like you have your system installed correctly and have nothing to worry…

For your 2013 Chevy Silverado 2500 you actually need a different Timbren part number due to the change in the bump stop that you mentioned. For that you'd need the part #TGMRTT35D instead. I attached a picture that shows how it attaches to the…

To help support a heavier truck camper like your Northstar Liberty that's going to give you a pretty consistent load the best option is with a Timbren Suspension Enhancement System. For your 2016 Chevy Silverado 1500 the Timbren #TGMRCK15S for…

The use of rear suspension enhancement along with a weight distribution kit is not recommended. They will tend to work against one another. If sag on your 2008 Ford F-150 is caused by a load or a fifth wheel or gooseneck trailer then suspension…

The overall outside to outside dimensions of the MORryde Sliding Tray for RV Cargo Compartment #MR84FR is 90 inch by 20 inch.

Both the Curt TruTrack 2P Weight Distribution System #C69JR and Reese Pro Round Bar Weight Distribution #RE44FR are going to use a 2-5/16" Ball #C40030 with a 1-1/4" shank. You will want to use the 2" Ball #A-90 to switch to a 2"…

You are going to need a different system like the Fastway e2 Weight Distribution #FA92-00-0800 which is rated for a tongue weight of 400-800lbs and trailer weight up to 8,000lbs. The Curt TruTrack 2P Weight Distribution System #C69JR is only offered…

Yes, it is possible for the Frame Brackets #C17508 to sag on your Curt TruTrack 2P Weight Distribution System #C69JR. Even the Trunnion Spring Bar #C17536 can begin to warp over time from the weight. While Curt does give this weight distribution a…

In order to choose the correct weight distribution system shank length, you'll need to measure. In regards to the Blue Ox 13K TrackPro Weight Distribution System, they come with a 7-hole part #BLU27FR and 9-hole part #BLU59FR. The max drop for…

Generally speaking, it is not advisable to reverse a trailer when using a weight distribution system. The system won't blow up but if you reverse at too sharp an angle then you can damage the head so you have to do so in a pretty straight line or…