Trailer Brake Controller Installation - 2000 Ford Expedition Video

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

The Redarc Tow-Pro Liberty #RED24FR is the way to go over the Elite #RED44FR as you get the nicer functions of the Elite at a lower price. The Elite has the ability to be the more preferred proportional style of controller as well as a time-delayed…

Your 2016 Honda Pilot will have a trailer wiring plug behind the driver's side at the rear by your tail lights. I've attached a video of the Curt #C56291 harness to assist. The Curt wiring harness #CU86FR is the 7-way wiring harness that…

The connector is gray in color, and should be located next to or behind the diagnostic port under the steering column, as you can see in the install video I'll link for you. You'll also need the #3035-P brake controller wiring adapter. One…

To install the Tekonsha Prodigy P3 #90195 in your 2016 Toyota Tacoma, you'll need the #3031-P Brake Controller Wiring Adapter Harness. The connector you're looking for is located behind the kick panel where it meets the firewall as shown in…

In 7-way wiring the trailer brake circuit's contact/pin is next to the contact for the right turn/stop circuit. What can happen is that corrosion can build up on or inside either the truck socket or the trailer plug and this corrosive build-up…

On your 2002 Ford F-250 you will need to connect the Red wire to the Black wire on the brake controller for +12 Volts power and the Light Green wire to the Red Stoplight wire on the brake controller. The Dark Blue wire is connected to the Blue wire…

To find the correct brake light switch wire on your 2017 Mazda CX-5 you will need to use a circuit tester such as #PTW2993 and find the wire that only shows power when the brake pedal is depressed; that will be the correct wire to hook up. To install…

There are a few different places the port on the 2002 Ford Expedition may be hiding. First, check the area beneath the dash, near the center console. It may be tucked up in there behind other wiring and you may need to remove an underdash panel. If…

One of the components needed to install a brake controller in your 1999 Ford Expedition is the part #37185 that you referenced. You would also need a brake controller and install harness. For a brake controller I would recommend the Prodigy P2 Brake…

If you have exactly 11 inches from the ground to the bottom of the B&W Tow & Stow 3-Ball Mount #BWTS10048B you'd be totally fine. It only might be an issue if you went on unusually uneven terrain like off-roading. But 11 inches would be…

For a simple cam lock, you can get an old standard blade screwdriver that you don't care about messing up. Use a hammer and drive the screwdriver into the key slot, the further the better. Use a pipe wrench on the screwdriver handle, and turn. In…