SumoSprings Solo Front Helper Springs Installation - 2012 Chevrolet Silverado Video

I spoke with my contact at SuperSprings to find out if this would present any issues for you. Although the amount of compression you are describing with the #TSS-107-40 installed is not ideal, they assured me that the system would still work as…

When installing the Sumo Trailer Springs #TSS-107-40, is very important as the Trailer SumoSprings provide the maximum level of vibration reduction and damping with the 1/4”-1/2” preload. That being said, the measurement is extremely close and after…

The correct SumoSprings Trailer Helper Springs for overslung axles (axle under leaf springs) is part #TSS-107-40. The springs will be pre-loaded upon installation therefore the space you have between the frame is spring loaded will be less than the…

Sounds like you are trying to pull the metal contacts out of the quick connect assembly. What you'll need to do is insert a slot screwdriver down into the opening end of the connector with the slot perpendicular to the opening so that you can…

Yes, the Pop & Lock Power Lock Conversion Kit for Truck Caps and Hard Tonneau Covers part #PAL9772 or part #PAL9555 will work on the Leer 100XQ Truck Caps because it uses a cable latching mechanism and the handle is not riveted on.

If you are considering Timbrens like the #TDR1500DQ and the SumoSprings like the #SSR-307-47 for your 2022 Ram 1500 4x4, I recommend the SumoSprings #SSR-307-47. The SumoSprings will offer the same quality as the Timbrens in terms of suspension…

For your 2018 Chevy Silverado 2500 the Timbren front suspension kit part #TGMFK25D is a confirmed fit since your truck is an HD. I am not sure where you are seeing that it's an inch taller than your current setup but this will fit and work well…

I found the article you mentioned from Timbren and a 1 inch gap is recommended for the rear kits but for the front kits they recommend no gap at all. Since the part #TGMFK25D is a front kit you'd want to not have any gap at all.

With the 2022 Host truck camper putting the majority of the weight above the rear axle you will benefit more with a rear sway bar. The Roadmaster Rear Anti-Sway Bar #RM-1109-169 for your 2019 Chevrolet Silverado 3500 will help reduce the body roll…

The differences between the Timbren Jounce Springs for your 2021 Chevy Silverado 2500 are listed below: 8,000 lb. capacity Front- Timbren Front Suspension Enhancement System #TGMFK25D (standard duty) Rear- Timbren Rear Suspension Enhancement System…

All of the scissor step assemblies we offer can be seen on the included link. Most are 18- or 20-inches wide but we do have three that are 24-inches which is the widest that we offer. For example, Brophy RV Scissor Steps #AS24 can extend up to…

The 4 step Brophy Camper Scissor Steps, #AS24 is recommended for an entry height of 31" - 40" while the 5 step model, #AS25 crosses over for an entry height of 40" - 48". My recommendation is to go with the 5 step model that…