Pace Edwards Switchblade Retractable Hard Tonneau Cover Installation - 2024 Chevrolet Silverado 1500 Video

In order to pick out the correct hub assembly for a trailer you are going to need know a few key pieces of information as we don't have a way to pull up what your trailer would have. The first thing you will need to know is the bolt pattern of…

The attachment bolts for a 5-bolt brake assembly like the part #AKEBRK-6R should be torqued to 30-50 foot/lbs. If you don't have a torque wrench handy, if you tighten the bolts until the lock washers flatten out, you'll be pretty darn close…

There is no specific torque rating for the castle nut that holds your hub in place. We recommend tightening the castle nut down until it stops, and then backing it off to the next notch wheel the tang washer will fit into the castle nut. Over…

A 2023 Chevy Silverado 1500 will need to have 4WD and a two-speed transfer case, which will need to be placed in neutral, in order to safely flat tow. Your owner's manual will have a list of instructions to follow to switch your transfer case…

Mixing and matching the brackets and air springs isn't really recommended but you might be able to get a combination to work. If I were you I would just put the complete #AL88288 kit on since that would fit properly and there wouldn't be any…

Hey Brian, so according to TorkLift they don't have any tie downs for the front but for the rear you are going to want the TorkLift Camper Tie-Downs #TL54FR. Since your truck has factory running boards that extend under the bed, there aren't…

Yes, I have listed for your below the roof rack systems from Rhino-Rack, Thule, and Yakima that will fit the RetraxPRO XR Hard Tonneau Covers like part #RTT-80243 for your 2019 Ram 1500. Rhino-Rack Vortex Crossbar System part #RRVA180B-RRRLT600…

To determine the size of the hub assembly you need to purchase you have to determine which bearings are in the old assembly. If the old assembly has L44649 inner bearings, you would use the hub you chose #8-258-5UC1. If the inner bearings are marked…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

There's not many differences between the Air Lift WirelessONE item #AL25980EZ and item #AL25980. The main difference is that the item #AL25980EZ has a slightly higher CFM at 1.03 compared to 0.92 and it runs slightly more efficient at 9% over 15%…

It's pretty easy to determine the correct replacement leaf springs for your trailers, and there's different ways for double-eye springs and slipper springs. You do have to account for the sag, so go with ones that measure shorter than what…