etrailer Class III Trailer Hitch Installation - 2019 Ram 1500 Classic Video

Since your 2017 Ram 1500 has a factory trailer hitch receiver the only way to replace it with a non factory one with be replacing the bumper support with one off of a truck that did not have a factory trailer hitch receiver. The reason for this is…

2013 and 2014 Dodge Ram Pickups use a different wiring harness than Rams from previous years. In the 2013 and 2014 models, the red stop light wire connects up above the gas pedal. The easiest way to install a brake controller into a 2013 or 2014…

When installing the Curt Trailer Hitch Receiver part #13333 you will use a half inch hex bit or allen. Generally in this case we use an impact type 1/2" hex bit on a large torque wrench. This tend to let us get tot he high torque spec of 320…

There are two harnesses under the dash of your 2014 Dodge Ram 1500 that are used for installing a brake controller. One carries ground, 12 volt power, and a circuit back to the 7-way of the truck and the smaller one carries just the stoplight…

I have another option for you, but since the Uriah Products Aluma-Tow HD8 8" Ball Mount UT625810 you have has the adjustment holes in the shank 1" apart it will not work with the Fastway e2 Weight Distribution w/ 2-Point Sway Control -…

I would recommend using the exact procedure you outlined. Tighten the shank bolts first and then with the shank in the vehicle hitch (secured with hitch pin) torque down the hitch ball to 450 ft lbs.

For your 2016 Ram 1500 that does not have a factory hitch the Draw Tite hitch part #75662 has been confirmed as a fit and would be a great option. I attached an install video for you to check out as well. For a ball mount kit you would want the part…