Where are Connectors on 2014 Dodge Ram 1500 that Are Used to Install Brake Controller

Question:

where is the factory wire for 2014 Dodge Ram 1500

asked by: Lutz

Expert Reply:

There are two harnesses under the dash of your 2014 Dodge Ram 1500 that are used for installing a brake controller. One carries ground, 12 volt power, and a circuit back to the 7-way of the truck and the smaller one carries just the stoplight circuit. Sounds like you are looking for the one that carries just the brake signal. For that you'll be looking for a small harness above the brake pedal. I attached a picture of where you'd find it but I the easiest way to see it will be to check out the install video I attached right at the 1:19 mark.

The harness used in the video is the part # 3023-P.

expert reply by: Jameson C