Draw-Tite Max-Frame Trailer Hitch Installation - 2020 Jeep Grand Cherokee Video

I can help explain the difference between the listing for towing weight and weight distribution towing capacity for you. Let's use the Draw-Tite Class V Trailer Hitch #DT45502, which is a confirmed fit for you 1992 Ford, that you were looking at.…

Since you don't have the tow package wiring on your 2019 Jeep Grand Cherokee, the Tekonsha T-One Vehicle Wiring Harness with 4-Pole Flat Trailer Connector #118727 is needed. This harness will connect behind your vehicle tail lights and will…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

The plug to connect the #3014-P harness in your 2019 Jeep Cherokee to is behind a black cover that is just to the left of the steering column right above where the carpeting ends. You need to remove the black cover. Check out the picture I attached.…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

To get a 4-pole wiring harness for your 2021 Jeep Grand Cherokee without a factory tow package, the T-One Harness that you referenced, part #118727, is in fact the correct kit to install. This kit comes with everything you need for installation. It…

If you click on the link to the installation instructions, at the bottom of the instruction sheet, right under the step-by-step run through of the install steps, you'll see the torque specs. We don't publish them because the hitch…

Yes, for your 2018 Jeep Grand Cherokee, you will need to remove the bumper/fascia in order to install the Draw-Tite hitch that fits: - Draw-Tite Max-Frame Trailer Hitch Receiver #DT38MR The reason why is because this hitch is totally concealed behind…

If your 2018 Jeep Grand Cherokee has the factory tow package and you are using the Curt T-Connector Vehicle Wiring Harnesse #C55774 you will need to go to your local Jeep dealer and have them re-flash your Jeep's computer in order to activate the…

The Draw Tite hitch part #DT38MR is a confirmed fit for your 2014 Jeep Grand Cherokee Laredo and would still fit whether you had the removable rear fascia or not. At worst you'd just have to trim the rear fascia of your vehicle so that your hitch…

If your 2015 Grand Cherokee has the factory tow package, you will have a connector at the rear of your vehicle behind the bumper. The harness I recommend is the Curt T-Connector Vehicle Wiring Harness, part #C55774. This just plugs into the round…

The Tekonsha harness part #118727 is the better option for your 2017 Jeep Grand Cherokee over the Curt #C62VR. The Tekonsha has a higher amperage rating so it will be more resistant to damage from an accidental short and also has a reputation for…