Draw-Tite Sportframe Trailer Hitch Installation - 2018 Hyundai Ioniq Video

The Draw-Tite #24965 and Curt #C11402 are a lot alike. They both install on your 2018 Hyundai Sonata in basically the same fashion and have the same weight capacities. They do look a little different because the Draw-Tite has a square cross tube and…

The Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2" #75282 requires all hardware be torqued to 68 foot pounds according to the instructions. I've attached a photo in case you need anything else for this installation…

The Class III #75282 Draw-Tite Trailer Hitch that you are interested in does comes with the six bolts needed to secure the hitch to the existing weld nuts in the frame. All of our hitches are shipped with the necessary installation hardware. If you…

I think I can help you but we don't have an install video of the Draw-Tite hitch, part #24963, being installed on to a 2019 Hyundai Ioniq. Check out the video I did link. It's for the Curt hitch, part #C11486, that fits the same model years…

The Draw-Tite Hitch item #24963 comes with four M10 X 1.25 X 30 CL10.9 bolts. The best way to prep the weldnuts on your 2018 Hyundai Ioniq is to clean them out with a wire brush. I have linked an installation video below that we did on a 2018 Ioniq…

According to my research the 2021 and 2022 model years for the Hyundai Ioniq are pretty much identical so both the Curt #C11486 and Draw-Tite #24963 Class I hitches will fit just fine on your 2022 model. We've actually had a few customers install…

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

You will need the Red LED Trailer Clearance or Side Marker Light #328-K-52 or Amber LED Trailer Clearance or Side Marker Light #328-K-51 for your 2018 Forest River Sunseeker motorhome. These lenses have the same Top Command SAE-AP2-16 markings on the…

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

The old version of the #HBA-CAM used 4 wires, but the product was updated awhile back and now uses only two wires as shown in the photo on the product description page. The white wire from the HBA-CAM would tap into the white ground wire and the blue…

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…