Curt Trailer Hitch Installation - 2020 Chrysler Pacifica Video

Basically a lot depends on what you will be using the hitch for. If it is just for accessories such as a bike rack or cargo carrier than for the most part you will be fine with a Class II trailer hitch. If you will be towing then I would go with…

The Thule T2 Pro X #TH83GC carries 2 bikes, has a hitch lock but the bike locks are sold separately. It carries bikes up to 50 pound with a max tire width of 3 inches. The distance from the hitch pin to the closest part of the rack is 6-3/4 inches.…

The correct replacement rear wheel holder for a Thule T2 classic bike rack would be the part #7521568001. I confirmed this with Thule just now.

The biggest change between the Thule T2 Pro and Pro XT #TH83JV is the distance between the bikes. Originally the T2 Pro was designed to work with Fat bikes right out of the box. The only issue was people had a hard time getting 2 Fat bikes to fit…

I believe you are asking about wiring for a third brake light on your Leer camper shell on a 2012 Ford F-150 (there isn't any type of wiring harness for a Leer camper shell we can offer), and for that, all you need to do is use a simple part: -…

The Tekonsha wiring harness part #118712 plugs into the vehicle's wiring harness behind the driver's side and passenger-side tail lights. The tail lights need to be temporarily removed to find the wiring harness to plug into. There are two…

On an aluminum trailer I would recommend you ground the brakes by running the ground wire back up to the ground circuit of the connector on the trailer. Aluminum frames do not make the best ground points so I wouldn't ground the assemblies to the…

Though I can provide the distance from the center of the pin hole to the closest edge of the bumper on the hitches we have installed, I cannot on the one we have not. This is the Curt Class II #C12180, unfortunately. That being said, the measurements…

There are a couple of possible reasons why the center mounting flange on Curt trailer hitch #13328 is not lining up with the holes in your 2007 Honda Pilot. First, sometimes in the shipping process a hitch can flex. As long as there are no…

When using the included fishwire tool, also known as a bolt leader, when installing a trailer hitch like the Curt Trailer Hitch #C11386 that fits a 2008 Mazda 3, the bolt leader will simply thread on and off the bolts. There isn't a trick to it,…

Typically when people remove a trailer hitch receiver that uses bolts that need to be installed using a fishwire like those found on the Curt Trailer Hitch Receiver #C11529 for your 2020 Hyundai Kona, they carefully remove the hitch and reinstall the…

I checked with my contact at Curt and confirmed that the Curt Trailer Hitch Receiver - Custom Fit - Class III - 2" #C65CR you were looking at is a confirmed fit for your 2020 Chrysler Pacifica AWD Launch Edition. The #C65CR has a 400lb tongue…