Review of Performance Tool Work Lights - Under Hood LED Light Bar - PT67RR Video

The Angle Trim for Enclosed Trailer #36290-955 being made of aluminum is easily bendable if done correctly. To bend this around a radius you will need to make relief cuts into the radius so that it does not split or crack the aluminum.

The E-Track Wood Beam Socket #59149 that you referenced doesn't have a capacity listed for it because the wood installed in it would break long before it would. Using it with angle iron instead of wood like it was intended for would make it…

I would recommend that you run the tracks horizontally, that way you could secure your Harley from multiple points around the bike to the E-Track Trailer Cargo Control - Horizontal - 5 Foot Long, part #E19148. I included a link to a video review of…

The E-Track Wood Beam Socket you mention, part #59149 can be mounted in any orientation you wish.As you can see in the photo I provided, the slots in the E-Track measure 2 inches apart on center. Moving from one slot to the next would provide 2…

The main difference between the horizontal and vertical E-tracks is which way the slots on the bar run. The horizontal E-track cargo control like part #E19148 can be mounted horizontally on the wall or floor in an enclosed cargo or open trailer. It…

I may have a solution for you, but we don't have any angled trim that is 1-1/2" x 1". The closest available angled trim we currently have available is the Angle Trim for Enclosed Trailer - 93-1/2" Long x…

Yes, you can use wood screws to secure the e-tracks to the plywood walls in your trailer. However, as you mentioned the weight capacity would be less than if you were to attach them to metal beams. The tracks themselves can handle up to 2,000 lbs…

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two…

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion…

Choosing the right height setting for your 5th wheel hitch is a combination of a few different variables. First of all you want your towing setup to be as level as possible. With your Montana High Country 340BH level you will want to measure from…

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…