Review of Lippert Components - Trailer Leaf Spring Suspension - LC126197 Video

The exact bolt replacement you need is the part #LC126197 which is the correct length and diameter plus has the zerk fitting on the end of the bolt as well.

Increasing the tire and wheel size can increase the height of the trailer but it's usually quite minimal. Before you do anything else you should see if the pin box can be adjusted. Although you have to be careful here since This will lower the…

The recommended lug nut torque for your 7,000lb axle depends on a few factors like wheel size, stud size etc. Check out the attached photo which shows the torque specs for a variety of applications. I see you were looking at the Dexter Nev-R-Adjust…

Lippert has been transitioning from the old school yellow paint to the new blue pain on the Road Armor Equalizers #LC696740 so you'll be getting blue. With that said color doesn't matter, and instead you need to worry about using the right…

Appreciate the photo it was very helpful; and since your hanger is 5 inches tall, you do indeed have the right Correct Track hanger replacement, which is the following part number: - Replacement Lippert Correct Track Weld-On Axle Hanger #LC303918

Yes of course. The Replacement Lippert Components Correct Track Weld-On Axle Hanger part #LC303918 you mentioned is 5" tall x 3-1/2" wide x 3-1/4" deep and the two mounting holes on the top are 1-3/4" apart on center as shown in…

For your 2018 Heartland Road Warrior Toy Hauler you will need a Correct Track Replacement Hanger. We have them 4" Tall #LC303917 or 5" Tall #LC303918.

The Lippert Correct Track Hanger part #LC303918 was designed to be used with leaf springs that are 1-3/4 inches wide like you have. You would not need to use a spacer with your 1-3/4 inch wide springs.

Both the MORryde Rubber Equalizers #MR87ZR and Dexter E-Z Flex Suspension Kit #K71-652-00 are achieving the same result. They are doing so with slightly different designs but end up with the same result. I recommend using the Dexter E-Z Flex…

For a replacement wet bolt on your Road Armor #LC696740 you can use the #LC126197. For a flange nut you can use #LC122103. If you're looking for the full AP kit the correct part is #LC52SV.

Most likely there is some old grease inside the bolt that's clogging things up. You can raise the trailer up and remove the wet bolt in question to give it a thorough cleaning or just simply replace the bolt altogether. Unfortunately there's…

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.