2004 Volvo V70 Vehicle Air Mattress

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

Hey Jeremy, Typically with boat trailers the manufacturer will install hydraulic surge brakes because you don't have to worry about the water damaging wires like you would with electric brakes. That being said, if you use a heat shrink…

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

I have a recommendation for you as when I reached out to EcoHitch and they said they do not have an option for 2023 Mini Cooper Countryman All4 PHEV. We do have the Stealth Hitches Hidden Trailer Hitch Receiver w/ Towing Kit #SH92QR. This includes…

Since the AirBedz XUV Air Mattress #Item #341031 has wheel well cut outs you wouldn't be able to use a fitted sheet. You'd instead need to use a non-fitted sheet or even just a blanket. The dimensions of the mattress are 66"…

Since your 2024 Telluride X-Line is not an LS or S model the correct wiring harness is the Curt #C29ZV. This will plug into the connection points in the rear cargo area and provide you with a 4-way to power your trailer's signal lights. The…

Hey Jeff, the WeatherTech ImpactLiner Custom Truck Bed Mat #WT99KF would get secured to your bed using the TechHold Retention Device (see image attached) which is just a adhesive ball and socket. Basically, one the ball end would get stuck to the…

In order to install a 7-way trailer connector on a 2022 Mazda CX-9 you'll need to start with a 4-way, the T-One Vehicle Wiring Harness for Factory Tow Package part #118278 which is plug-in-play. Then you can adapt this into a 7-way using the…

Yes, it does! The etrailer Hitch item #e75ZR has been confirmed to fit all models of the 2024 Toyota Highlander including the hybrid. This class III hitch with a 2" receiver is custom fit and bolts to your Highlander with included hardware.…

We have the etrailer hitch part #e75ZR that fits your 2024 Toyota Highlander Hybrid that I would recommend. It has great towing capacities and is mostly hidden since only the hitch opening hangs below the rear bumper.

In regards to the Replacement Clamp Assembly for Yakima SlimShady Roll-Out Awning part #8880737, the handle on the side of the unit is used to tighten the c-shaped clamps around the crossbar. The rubber inserts inside the c-shaped clamps are then…

The B&W Continuum #BW78FR and the Reese Strait-Line #RP66083 are both great systems. The B&W Continuum is going to be easier to set up, but as far as sway control goes, I definitely have to give the edge to the Reese Strait-Line.…