Where Does the White Wire of the Curt Wiring Harness # C56039 Go on a 2011 Mitsubishi Endeavor
Question:
no directions to do what with white wire lug connector on factory plug side
asked by: Randy
1
Helpful Expert Reply:
The white wire you referenced actually needs to get run to a clean metal surface on the body of your 2011 Mitsubishi Endeavor with the included self tapping bolt through the ring terminal.
This grounds the converter and allows it to function properly.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Powered Converter
- Custom Fit
- 4 Flat
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Trailer Wiring Harness for 2004 Mitsubishi Endeavor
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Bolts Provided with Hitch Will Not Fit in Nuts Welded Into Vehicle Frame
- Article: How to Choose the Right Trailer Hitch Class
- Article: Ball Mount Basics: Weight Capacity, Class, and Size
- Q&A: Do I Need To Lower My Muffler To Install This Hitch?
- Q&A: Hitch and Wiring Install Instructions for a 2011 Mitsubishi Endeavor
- Q&A: Where Does the 4-Flat Connector from Wiring Harness # C56039 go on a 2010 Mitsubishi Endeavor
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Trailer Tires to Replace P165/80-13 and B78-13 Tires on a Boat Trailer