D-Ring Tie Down Anchor Recommendation for Securing 1,600 lb UTV
Question:
I am considering these for use on a utility trailer and a 1600 lb side x side utv. I would use two of these for each wheel and would use tire bonnets/nets. Therefore, I would need a total of 8.
asked by: Blair
0
Expert Reply:
Yes, the Brophy D-Ring Anchor # RR01-C that you referenced would do a great job to secure the UTV you plan on transporting in your trailer. Especially since you plan on using 8 of them and these have a 1,200 lb capacity each.
For tie downs you would want the part # SM54FR.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Brophy D-Ring Tie Down Anchor - Bolt-On - 3-9/16" Wide - Recessed Mount - 400 lbs
- Tie Down Anchors
- Trailer Tie-Down Anchors
- Truck Tie-Down Anchors
- Tie-Down Cleats and Rings
- 400 lbs
- D-Ring
- Recessed Mount
- Brophy
more information >
Continue Researching
- Q&A: Replacement Rod and Nut for a Bulldog 12,000 lb Trailer Jack
- Article: Trailer Lighting Requirements
- Article: Most Popular Wheel Bearings
- Q&A: Fully Extended Height Of The Ark Drop Down Croner RV Stabilizer Jacks
- Q&A: How to Find Connector for Back Up Sensors When Installing 118760 Trailer Wiring on 2019 Honda Pilot
- Q&A: Best Way to Prevent Sagging Suspension When Towing a Trailer
- Q&A: Do I Have to Remove My Tires to Install the Timbren Springs # TTORTUN4 on My 2021 Toyota Tundra?
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Q&A: How Does Deka Battery Isolator # DW08770 Wire to Dual Battery Setup
- Q&A: Replacement Clearance Lights Needed for GLO-BRITE 122R and 122Y Lights
- Article: Basics of Tie-Down Anchors
- Article: Trailer Wiring Diagrams
- Article: How to Measure for Trailer Hitch Drop
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box