How Does the Security Strap for Yakima Trunk Mounted Bike Carrier # Y02623 Work

Question

Question:

Could you explain to me how this security strap works? Thanks!

asked by: Sherry K

0

Expert Reply:

To use the Security Strap for Yakima Trunk Mounted Bike Carrier # Y02623 you will need to run the loop end of the strap around any portion of the bike rack you can fit it on and then close the roller side in the rear hatch of your vehicle. To see how this is done check out the 1:00 minute mark of the video I attached to the right.

expert reply by: Jameson C

0

Answer 1

Offically Honda states your 2018 Honda Fit is not rated for towing a trailer. Since people will still tow and there is a demand for a hitch for your vehicle we have a hitch like the Curt part #C11406 which is a confirmed fit as well as trailer wiring…

view full answer...

Answer 2

You may be able to run the strap through backwards. Other than that there is no specific place the strap has to go. As long as the cylinder part is closed inside the vehicle and cannot be pulled out then that is all you will need to deter theft of…

view full answer...

Answer 3

I'll start off by saying that the Magnuson-Moss warranty act that states, in part, that unless the part added actually causes a problem, then installation and use of the part will not void the warranty; so basically, adding a trailer hitch will…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 6

What you're going to need is two of the transfer switches in that case. I have attached a diagram from Furrion that shows you how you're going to need to hook the two transfer switches #F30ATS up: -one to the other, then one branching off to…

view full answer...

Answer 7

I checked your order notes and the leaf springs you bought last year were the part #e28SR which are for 5k axles. Since this is over the capacity of your axle failure would not have been caused by over loading the trailer assuming you stayed under…

view full answer...

Answer 8

The Dexter 072-078-00 is a 2,200 lb capacity leaf spring. You can use a higher capacity leaf spring, however it won't increase the capacity of your trailer as the axle is still rated for that max capacity of 4,400 lbs. My recommendation for a…

view full answer...

Answer 9

Based on my research, the Trailer Hub and Drum Assembly - 8,000-lb E-Z Lube Axles #AKHD-865-8-EZ-K will be a replacement for the 90865 Rockwell hub and drum. Both of these hub and drum assemblies are 12-1/4" diameter, have an 8,000 lb capacity,…

view full answer...

Answer 10

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

How Does the Security Strap for Yakima Trunk Mounted Bike Carrier # Y02623 Work

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching