Will Air Lift Helper Springs Help Rear End Sag On 2010 Toyota Sienna When Carrying Bikes
Question:
Dear Sir/Madam, I have a question about Airlift 1000 system code # AL60732. I have a Toyota Sienna XLE 2010 and it has about 60K miles on it already. I recently installed a Curt 13105 class 3 trailer hitch and a 4 bike rack. This made my van sag very low and scratch the surface of the driveway. Will this system work with my 2010 Toyota Sienna XLE van? Please advise.
asked by: Khoi N
Expert Reply:
The Air Lift AirLift 1000 Air Helper Springs, part # AL60732, are designed to fit your 2010 Toyota Sienna. They will help prevent the rear end sag you have when your have your bikes all loaded up. These air bag fit inside the coil springs on your Sienna and will help reduce the stress on your Sienna suspension. I have attached a link to an installation video for this system on a Sienna you can check out.
For easier control of the air spring system, I recommend the Air Lift Load Controller I Compressor, part # AL25651. This system includes an onboard compressor and allows you to monitor and control the system from the comfort of your driver's seat. With the dual controls, you can make adjustments for any uneven loads.
Products Referenced in This Question
Air Lift Load Controller I Compressor System for Air Helper Springs - Dual Path
- Air Suspension Compressor Kit
- Wired Control
- Dual Path
- Analog Display
- Air Lift
more information >
Product Page this Question was Asked From
Air Lift 1000 Air Helper Springs for Coil Springs - Rear
- Vehicle Suspension
- Rear Axle Suspension Enhancement
- Air Springs
- Light Duty
- Air Lift
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Suspension Enhancement
- Shop: Air Lift 1000 Air Helper Springs for Coil Springs - Rear
- Shop: Trailer Wiring
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: Floor Mats
- Shop: Brake Controller
- Shop: Redarc Tow-Pro Liberty Brake Controller - Dash Knob - 1 to 2 Axles - Proportional
- Q&A: When Installing Trailer Wiring in a 2015 Toyota Sienna Does Power Wire Have to Run to Battery
- Shop: Trailer Hitch
- Shop: Replacement Inflation Valve Bracket for Firestone Air Command Compressor Systems
- Shop: Draw-Tite Max-Frame Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Shop: Mounting Bracket 4-Pole Flat
- Shop: etrailer Trailer Hitch Receiver - Custom Fit - Matte Black Finish - Class III - 2"
- Q&A: Recommended Air Suspension System For 2005 Toyota Sienna For Towing
- Q&A: What Is Needed To Install AirLift 1000 Air Helper Springs On a 2006 Toyota Sienna
- Q&A: Does Air Lift 1000 Air Bag Kit Fit 2020 Toyota Sienna
- Q&A: Concealed Trailer Hitch Fit for 2020 Toyota Sienna
- Q&A: Best Trailer Hitch For 2020 Toyota Sienna
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Video: Choosing the Right Trailer Wiring
- Search Results: hitch
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Video: Choosing the Right Brake Controller
- Article: How to Choose the Right Trailer Hitch Class
- Search Results: trailer hitch
- Article: Trailer Wiring Diagrams
- Search Results: air bags
- Search Results: brake controller
- Video: Tow Ready 4-Pole Mounting Bracket Installation
- Article: How to Measure for Trailer Hitch Drop
on Vehicle Suspension
