RV Spare Tire Cover Recommendation for a ST205/75R14 Tire

Question

Question:

My tire size is ST205/75R14C. I looking for a black cover to fit on My RV trailers spare tire.

asked by: James O

0

Expert Reply:

Based on your ST205/75R14C tire size that you have the Classic Accessories Universal Fit Spare Tire Cover # 052963753479 that you referenced would work well for you. This cover is black and is confirmed to fit your tire size.

Check out the review video I attached for this product as well.

expert reply by: Jameson C

0

Answer 1

Your ST235/80R16 spare tire when fully inflated does indeed have an overall diameter of about 31-inches so your measurement is right on. For reference the linked article includes a chart that shows the overall diameters of various trailer tire sizes.…

view full answer...

Answer 2

For your ST205/75R14 tires, I recommend the Adco Ultra Tyre Gard RV Wheel Covers - Single Axle - 24" to 26" - Vinyl - White - Qty 2 #290-3954. These tire covers will fit snug for your tires in a storage situation to protect them and extend…

view full answer...

Answer 3

For a ST205/175R14 tire the overall diameter is about 26.3 inches, so you would look for a cover that is close to that size for a spare tire cover. The spare tire cover you referenced, part #052963762402, would be a nice cover for the size tire you…

view full answer...

Answer 4

For a 205/75R14 sized tire I recommend a spare tire cover for a 27 inch tire like the Adco #290-1737, in black. It's also available in other colors: White #290-1757 Diamond Plate #290-9757 Camouflage #290-8757 US Flag #290-1787

view full answer...

Answer 5

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 6

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 7

A BT8 spindle would have a diameter of .99 of an inch where the bearings would both install and would have a diameter of 1.24 where the great seal would ride. That would require a hub part #AKIHUB-440-2-1K for an idler hub. A BTR spindle would have…

view full answer...

Answer 8

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 9

Hey Richard, thanks for reaching out! The Dexter DX7.5 Drop-N-Go Brake Actuator #099-175-00 is a great option for a replacement actuator because it's a direct replacement for the common Model 60 actuators that were popular in the '90s.…

view full answer...

Answer 10

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 11

I would use a protractor, see photo, place the protractor on the edge of the inside of one side of the trailer frame and the other inside edge of the trailer frame should be parallel with the 50 degree line on the protractor. Another way to verify…

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

RV Spare Tire Cover Recommendation for a ST205/75R14 Tire

Featured Help Information

Miscellaneous Media

Continue Researching