Installation Instructions for the Hopkins Trailer Hitch Level # HM09715

Question

Question:

I have lost my instructions. Are you able to send them to me.

asked by: Cj

1

Helpful Expert Reply:

I went out into our warehouse and pulled a Hopkins Trailer Hitch Level # HM09715 and took pictures of the installation instructions. I attached them to this page for you to check out.

expert reply by: Jameson C

1

click to enlarge

Answer 1

Thanks for sending in a picture of your thumb latch coupler and trailer jack. Based on seeing that we know the Hopkins Trailer Hitch Level with Cover part #HM09715 would fit and work great as we had chance to install this on the exact same coupler as…

view full answer...

Answer 2

You will want to use a cobalt or titanium drill bit when drilling the 5/32-in pilot hole for the #HM09715 hitch level. These type bits are used for harder metal and will do a better job than just a steel or high-speed steel bit as they will dull…

view full answer...

Answer 3

For the factory-installed hitch receiver on your 2013 Ford Edge, I recommend the Brophy Ball Mount #BM20. It has a 3/4 inch rise and a 2 inch drop with a weight capacity of 10,000 lbs, which should be more than sufficient for your 188 inch R-Pod. You…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 6

For sag from towing a trailer the best recommendation I can make is actually a weight distribution system. Suspension enhancement will help level your truck while towing. But the advantage to a weight distribution system is that it levels the vehicle…

view full answer...

Answer 7

The difference between an load range C and load range D tire in the same size is the capacity and psi rating. The two tires will still have the same dimensions and fit on the same wheel. The D rated tire has a higher capacity. For a ST175/80D13 like…

view full answer...

Answer 8

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 9

Trailer wheel bearings are specific to the spindle that is installed on the axle that is on your trailer. You will need to safely support the trailer, remove the wheel and tire, remove the grease cap, remove the cotter pin and washer that secures the…

view full answer...

Answer 10

The 5.30-12 tires, being wider, are going to make more contact with the road. This means that the noise, and heat build up will be higher than a 4.80-12 tire but the rolling resistance will actually be less because the tire is larger diameter. The…

view full answer...

Answer 11

Load range B trailer tires are going to have a lower capacity than C load range tires. Basically that, psi rating, and the ply rating are the only differences. A higher load range tire would last a little longer than lower load ranges of the same…

view full answer...

Answer 12

To find the load capacity for your axle you should look on the trailer VIN plate or sticker that lists the VIN number. The weight rating of the axle should be listed on that same plate or sticker. Also, the axle could have a tag or plate on it that…

view full answer...

Installation Instructions for the Hopkins Trailer Hitch Level # HM09715

Product Page this Question was Asked From

Continue Researching