Dimensions of the Mounting Stud Slot of the Dutton Lainson Winch Handle part # DL70326
Question:
I have lost the handle for an old manual winch, single speed. There is no mfg. name on the winch. The shaft over which the handle fits is ½inch in diameter over the threaded part. The flattened section is ?inch across the flats. Would your DL70326 handle work as a replacement? My thanks for your help
asked by: Joe A
0
Expert Reply:
I went and pulled a Dutton Lainson Winch Handle part # DL70326 from our warehouse to measure the slot and found the dimensions to be 1/2 of an inch by 3/8 of an inch. If the dimensions of your winch handle are the same this handle should work well for you.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
9-1/2" Long Winch Replacement Handle by Dutton-Lainson
- Accessories and Parts
- Trailer Winch
- Handles
- 9-1/2 Inch Long
- Dutton-Lainson
more information >
Continue Researching
- Q&A: Replacement Handle for a Fulton T1801 Hand Winch
- Q&A: Is Replacement Handle for Bladex and Valterra Waste Valves Threaded
- Q&A: Available Replacement Winch Handle for Fulton T1801 Hand Winch
- Q&A: Short 6 Inch Handle for Dutton-Lainson Winch DL2000A
- Q&A: Replacement Hand Winch Handle for my 2,500 lb. Dock Winch
- Article: Trailer Maintenance Schedule
- Q&A: Shorter Handle for Dutton-Lainson Hand Winch
- Q&A: Recommended Replacement Winch for a Fulton T1801