What is the Pin Hole Size to Attach a Wheel or Foot on Pro Series 2K A-Frame Trailer Jack

Question

Question:

What is the size of the hole for the pin on the inner tube?

asked by: Joel L

0

Expert Reply:

On Pro Series trailer jack # PSRV20000103, the pin hole on the lower leg is approximately 3/8 of an inch in diameter. It is actually just slightly larger.

For a foot that will fit you can use # PS1400700340. Or for a wheel use # PS1400750340. The wheel is rated for 1,200 pounds so it would limit the jack to that same 1,200 pound capacity.

expert reply by: Michael H

0

Answer 1

Based on my research the Atwood jack 80274 was an A-frame type side-wind tongue jack with a 2K weight rating. The Pro Series jack #PSRV20000103 that you referenced is a suitable replacement for this discontinued product. The Pro Series offers a 2K…

view full answer...

Answer 2

From what you described I believe that you are correct that the Drop Leg for etrailer and Ram Jacks #JF-1005H-Z will fit the jack on your Jayco Jayflight SLX 174BH Trailer. This is designed to fit inside a jack with a 2" outer diameter tube like…

view full answer...

Answer 3

Thanks for the picture of your jack. From that I can tell that you have the Round A-Frame Trailer Jack #TJA-2002-B and the correct replacement foot you'll need is the #JF-1005H-Z that you mentioned. This will give you up to an additional 8 inches…

view full answer...

Answer 4

We have a jack that meets all of the requirements that you are asking about. The Round A-Frame Trailer Jack #TJA-5000S-B has a lift, or travel, of 15-5/8 inches. When this jack is fully extended, the bracket height it 24 inches. This jack also…

view full answer...

Answer 5

The Atwood jack 80274 was an A-frame type side-wind tongue jack with a 2K weight rating which we have several options for that would work great as a replacement. The Pro Series Round, A-Frame Jack w/ External Gearbox #PSRV20000103 that you referenced…

view full answer...

Answer 6

The Trailer Valet JXC Trailer Jack part #TV94FR will work on pretty much any a-frame trailer. It uses the standard mounting flange pattern and it can be rotated for better handle clearance so you don't have to worry about tongue accessories. We…

view full answer...

Answer 7

?The distance from the mounting plate to the foot on the Trailer Valet JX-2K #TV54FR is 13" when fully retracted. The distance from the mounting plate to the top of the jack is 23". This jack can provide you with up to 14" of lift on…

view full answer...

What is the Pin Hole Size to Attach a Wheel or Foot on Pro Series 2K A-Frame Trailer Jack

Products Referenced in This Question

Product Page this Question was Asked From

Continue Researching