Vehicle Side 4-Way Connector Without a Converter

Question

Question:

I have a Draw Tite trailer for my Melonseed skiff. I need the wiring harness for the trailer onlyflat 4 plugcar end is okay, I think. Sell apart from converter?

asked by: Richard

0

Expert Reply:

It sounds like you are looking for a vehicle side 4-way connector without a converter. If this is the case, we have the 4-Pole Vehicle End, # 18172, available.

If you are needing a connector for your trailer, Wesbar makes the 4 Pole Flat Connector with Jacketed Cable, # W787264.

Your vehicle information states that you have a 2007 Volkswagen Jetta. If you will be towing with this vehicle, it will require you to use a wiring harness with a converter like the Custom Fit Wiring Harness with Powered ModuLite, # C59496, due to the multiplex wiring on the Jetta.

expert reply by: Leah S

0

Answer 1

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 2

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 3

Normally trailer coupler height is around 17 inches, from the ground to the bottom of the coupler, and most hitch manufacturers design their hitches to work with a ball mount that will end up very close to this measurement. I am including a link to…

view full answer...

Answer 4

The Curt #C13382 and etrailer #e98912 hitches for your 2022 Subaru Crosstrek have the same construction, capacities, and design, but the big difference is that the Curt hitch has the classic glossy finish while the etrailer hitch has a matte black…

view full answer...

Answer 5

There is only one difference between the Curt Trailer Hitch Receiver #C13176 and etrailer Trailer Hitch Receiver #e98909 that fit your 2020 Chevrolet Colorado, which is the finish. The Curt trailer hitch has a glossy black finish while the etrailer…

view full answer...

Answer 6

The SumoSprings Rebel Custom Helper Springs - 2 Piece - Front Axle #SSF-170-40-2 are a confirmed fit and the two piece design does allow for the full suspension travel to allow your vehicle suspension to work to it's best capacity without…

view full answer...

Answer 7

I never recommend using grease with Nylon Bushings #TRBU11566. The grease can trap dirt which will cause the nylon to become damaged easier. And the chemicals in different greases can cause the nylon bushings to break down. If you want to use Grease…

view full answer...

Answer 8

All of the available winches run off of a 12V power source or 120V power source and do not run off 110V. The best way to use a winch is to use a 12V battery but if you do not have a 12V power source then you can use a converter to convert the 110V to…

view full answer...

Answer 9

I have some options for you, however, I am not familiar with an adapter to convert a 5 pin round trailer connector to a 4-pole flat trailer connector. Since your trike has a 5 pin trailer connector, the extra wire on your 5 pin connector will serve…

view full answer...

Answer 10

The outside diameter of the Pollak 5-pole Round Trailer Connector, part #PK11501 measures .80 inches.

view full answer...

Vehicle Side 4-Way Connector Without a Converter

Products Referenced in This Question

Product Page this Question was Asked From

Featured Help Information

Instructions

Miscellaneous Media

Continue Researching