Will the Curt Class I Trailer Hitch # C11222 Fit the 2012 Chevrolet Camaro LT or SS

Question

Question:

does the Curt Trailer Hitch for the 2012 Camaro by Chevrolet Curt Trailer Hitch Code: C11222 work for both the SS and LT? Is there one that works with ground effects ?

asked by: Larry

0

Expert Reply:

I spoke with my contact at Curt and he said they have not had any fit issues with the LT or SS models of the 2012 Chevrolet Camaro and the Curt Class I Trailer Hitch, # C11222, but we do not have any hitches that will fit models with ground effects. The reason for this is that trailer hitch manufacturers have determined that models with ground effects will require an excessive amount of trimming and cutting to install and use the trailer hitch.

expert reply by: John H

0

Answer 1

If your 2013 Camaro is a convertible and not equipped with the factory ground effects package, then we have the Curt Trailer Hitch #C11122 as a confirmed hitch. On the #C11122 Curt specifically states in the instructions that the #18050 stabilizing…

view full answer...

Answer 2

As long as you don't have ground effects we have a hitch that would work well for you. For a coupe 2015 Chevy Camaro you would want the Draw Tite hitch part #24850. If you have a convertible you would instead want the part #C11222.

view full answer...

Answer 3

Increasing tire width will not really benefit you in any significant way. You would see a slight increase in stability, but if the trailer already rides pretty straight, you may not see any improvement. The 5.30-12 tires would also make the trailer…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

I've never heard of an actual third brake light connector on a camper shell to plug in on a truck and we don't carry any parts to do that. The light generally needs to be hardwired into the truck's brake light circuit. The issue with this…

view full answer...

Answer 6

I did some checking and the hub/drum we offer that will work for you is the part #8-430-5UC3. This uses the same bearings as the 8-415 and will be an exact fit aside from the fact this is a non-ABS setup and the 8-415 came in an ABS setup and non-ABS…

view full answer...

Answer 7

If you are needing the hub and drum assembly then you will want to go with the Dexter Trailer Hub and Drum Assembly #8-201-5UC3-EZ but if you are just looking for an idler hub then you will want part #8-213-5UC1 instead. These come with the correct…

view full answer...

Answer 8

If the trailer wheels scrubbed (dragged and scrapped the ground instead of rolling) when jack knifed then it could have thrown something out of alignment or damaged something. First, inspect the suspension. Look for any elongated holes where…

view full answer...

Answer 9

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 10

Since Demco uses 3,500 drum brake assemblies part #DMSB24429M and #DMSB24428M what you'd need is similar 3,500 electric brake assemblies like the etrailer part #AKEBRK-35L-SA for the left hand side and #AKEBRK-35R-SA for the right hand side. To…

view full answer...

Answer 11

Since you have a wheelbase/axle spacing of 38 inches the correct hanger kit for slipper springs would be the part #HAP-105-205-01. And then for a 7k trailer axle the u-bolt kit you'd want would be the part #APUBR-8. I attached the diagram to use…

view full answer...

Answer 12

I would be happy to help you set up your 2022 Toyota Highlander to haul your new travel trailer. The wiring harness you currently have controls your trailer's lighting functions only. You do not need to rewire your Toyota you just need another…

view full answer...

Will the Curt Class I Trailer Hitch # C11222 Fit the 2012 Chevrolet Camaro LT or SS

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching