Does the Replacement Box with LED Lid for Engager Breakaway Kit Include Charger

Question

Question:

Does this include the charger?

asked by: Marcus V

0

Expert Reply:

Yes, the replacement box with LED lid # HM20121 does include the charging circuit board.

expert reply by: Michael H

0

Answer 1

We do offer a replacement battery box with LED lid for the Hopkins Engager Breakaway box. The part number for the box and lid is #HM20121 and the part number for the battery itself is #HM20008.

view full answer...

Answer 2

The black wire on the Engager breakaway system #20099 will be connected to a 12v auxiliary power wire coming off of the trailer connector. This wire is typically the number 4 black terminal in the 7-way connector, but you will need to test to…

view full answer...

Answer 3

First it is important to know that the battery on the Engager break away kit #20099 will only be charging as long as the 12 volt circuit is providing power. If you shut off the vehicle and disconnect the trailer it will not be charging. When there is…

view full answer...

Answer 4

If you found a broken solder joint and disconnected wire inside your trailer breakaway battery box like #20099 and you are sure of where the loose wire connects, then yes, you should be fine soldering the wire back into place on the circuit board.…

view full answer...

Answer 5

The Replacement Breakaway Box and LED Lid, #HM20121, is the replacement box for the Hopkins Engager Trailer Breakaway Kit, #HM2009. The Hopkins replacement box and lid will also include the charging circuit board.

view full answer...

Answer 6

The Bright Way Trailer Breakaway Kit #3802354 can be installed in a manner that either does or does not take a charge from the tow vehicle while it is running; the best way to complete an installation where it does take a maintenance charge from your…

view full answer...

Answer 7

I have attached the installation instructions for the Hopkins Engager Trailer BreakAway Kit, part #20099. This kit includes a charger and an LED tester and will work with single and tandem axle trailers. I have also attached a link to an installation…

view full answer...

Answer 8

In most trailer wiring installations, whether on the vehicle side or the trailer side, the ground runs through a WHITE wire. You can see how to wire your Replacement Breakaway Box #HM20121 by referring to the linked article on breakaway systems.

view full answer...

Answer 9

The Bright Way Push-to-Test Trailer Breakaway Kit #3802311 that you referenced comes with a 10 amp hour battery. I attached a picture of the battery outside of the box for you to check out as well. I attached a review video for this kit for you to…

view full answer...

Answer 10

From what I could find it looks like your 122R (red) and 122Y (amber) lights measure 3.75" x 1.70" x .81". We don't have any replacement lense directly for the GLO-BRITE lights but we do have some similar lights that you could use…

view full answer...

Answer 11

The manual lockout on your Atwood 85778 surge brake coupler is there so that you can back up the trailer without the brakes locking up on you. Yes you can safely tow your trailer with the broken manual lockout, you just have to make sure you…

view full answer...

Answer 12

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Does the Replacement Box with LED Lid for Engager Breakaway Kit Include Charger

Product Page this Question was Asked From

Continue Researching