Comparing The Curt # 31604 And Draw-Tite # 65003 Front-Mounted Trailer Hitches
Question:
Hello I’m interested in a front hitch for my 1995 Dodge ram 2500 4x4 diesel. I’m comparing the Curt 31604 and Draw tight 65003. My question is in relation to the final location of the receiver. Is one hitch’s final location higher up or closer to the lower edge of the front bumper? Meaning better ground clearance. The other question is concerning stick out or recession in relation to the front bumper. Which sticks out farther? It appears from the available photos that the Draw tight is mounted higher and further forward, and the Curt is lower and further recessed, but it is hard to tell. Any insight or specifications would be greatly appreciated.
asked by: Shawn M
Expert Reply:
Hey Shawn,
The dimensional differences between the Curt # 31604 and Draw-Tite # 65003 are so miniscule that there really isn't a better option from this point of view. The pictures are from different trim packages so it can be a bit deceiving on how it will actually fit with the front fascia. Both hitches are using the same mounting location so it's really going to come down to quality.
In my experience Curt has been the better option as they're hitches don't tend to get as bent up in shipping as Draw-Tite and their paint job does a better job of not flaking off. The safety chain loops are also more prominent so you'll have an easier time hooking onto them if you need them to pull someone else out of a ditch or have yourself pulled out as well. Because of these reasons I recommend going with the Curt # 31604.
Pro-tip: Don't cut any of the fascia until you dry fit the hitch in place to avoid cutting too much.
Products Referenced in This Question
Draw-Tite Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Front Receiver Hitch
- Custom Fit Hitch
- Front Mount Hitch
- 500 lbs Vert Load
- 9000 lbs Line Pull
- 2 Inch Hitch
- Square Tube
- Draw-Tite
more information >
Product Page this Question was Asked From
Curt Front Mount Trailer Hitch Receiver - Custom Fit - 2"
- Front Receiver Hitch
- Custom Fit Hitch
- Front Mount Hitch
- 500 lbs Vert Load
- 9000 lbs Line Pull
- 2 Inch Hitch
- Square Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Shop: Front Mount Hitch
- Q&A: Will Curt Front Hitch Fit 1999 Dodge Ram 2500 Diesel
- Q&A: Will Altering Bumper Allow Curt Front Mount Hitch to Fit 1999 Dodge Ram 2500 Sport
- Q&A: Front Hitch Recommendation for a 2002 Dodge Ram 2500 Sport
- Q&A: Front Mounted Hitch for a 1999 Dodge RAM 2500 Diesel
- Article: Stability Control for Heavy Duty Vehicles
- Q&A: Replacement Mounting Hardware for Buyers Products 15 Ton Pintle Hook
- Q&A: Does Factory Hardware on 1999 Dodge Ram Need to Removed for Front Mount Hitch Installation
- Q&A: Is Dual Ball Mount Available with Dual 2" Hitch Ball Sizes
- Article: My Trailer Hitch Doesn't Fit
- Article: How to Choose the Right Trailer Hitch Class
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: Routing the Power Wire for a Trailer Wiring Harness
- Article: How to Mount a Truck Bed Camper
- Article: Brake Controller Installation: Starting from Scratch
Shawn
4/24/2024
Thanks for your help